Loading ...
Loading ...
Loading ...
• Push the deck lift pedal and the deck release
pedal forward to unlock the deck lift.
• Push the deck lift pedal forward until the cutting
deck latches in the transport position.
• Push the deck release pedal forward to lower the
cutting deck into mow position.
To set the cutting height
1. Set the cutting deck in transport position. Refer
to
To set the cutting deck in transport position or
mow position on page 13
.
2. Push in the button on the top of the pin and pull
the pin out.
3. Put the pin in the hole for the correct cutting
height.
Note:
If you mow on 2 in./5.1 cm or lower,
examine if it is necessary to adjust the deck lift
springs. Refer to
To adjust the deck lift springs
on page 14
.
4. Push the release pedal forward to release the
transport latch and lower the cutting deck into
mow position.
To adjust the deck lift springs
Examine if it is necessary to adjust the deck lift
springs if you mow 2 in./5.1 cm or lower.
1. Tilt the seat forward.
2. Loosen the nut to adjust the spring tension.
To start the engine
1. Sit on the seat.
2. Push the PTO button to disengage the drive on
the cutting deck.
3. Set the cutting deck in transport position. Refer
to
To set the cutting deck in transport position or
mow position on page 13
.
4. Engage the parking brake. Refer to
To engage
and disengage the parking brake on page 13
.
5. Move the throttle lever (A) to ½ throttle position.
A
B
C
6. If the engine is cold, pull the choke control (B)
up.
7. Turn the fuel tank valve to select 1 of the 2 fuel
tanks.
8. Set the cutting height. Refer to
To set the cutting
height on page 14
.
9. Press and turn the ignition key to the start
position (C).
10. When the engine starts, immediately release the
ignition key to the run position.
Note:
Do not keep the ignition key in the start
position for more than 5 seconds at a time. If the
14 2171 - 001 - 14.06.2023
Loading ...
Loading ...
Loading ...