Loading ...
Loading ...
Loading ...
- 5 -
4. Insert one end of the connecting cable into the USB interface of the
top anemometer host, as shown in figure 24
Figure24
5.Insert other end of the connecting cable into free interface port of on
the computer back, as shown in figure 25
Figure 25
6. Online real time Measurement:
Click “Real Time Measure operation” in “File” menu or Real Time
Measure button, enter real time measuring mode. as show in figure.26
Figure 26
Button introduction:
Button
Function
Click to start real time measurement
Click it the data displayed again.
Click it the Wind Velocity and Temperature display range
getting smaller.
Click it the Wind Velocity and Temperature display range
getting bigger.
Click it the Wind Velocity and Temperature move left
side.
Click it the Wind Velocity and Temperature move right
side.
Note: the computer and the machine for real-time online measurement may
not directly disconnected, must secure delete again after pulling USB
interface.
Familiar trouble shooting
The following is a list of actions to be to ken if the unit is not working properly:
(1) Screen is blank
Check the battery is inserted correctly. Open the battery door
on the bottom rear of the unit. The “+” “-” symbols on the
battery should match the corresponding “+” “-” symbols on
the inside of the battery compartment.
(2) If the unit can not connect to PC normally, please check
the USB cable is OK, if the cable can not be used formally,
please replace for a new one.
(3) lf the unit can not read the wind flow value properly, please
check if the vane is block or not.
(4) If the unit can not read the wind temperature value properly,
please check if the heat resistor is fall off or damaged by
manual.
(5) If the unit can not read data properly, please check it is
operated under the rule temperature and humidity situation.
Note:
When not connecting to PC, the unit will power off automatically after
10 minutes if no any operation after power on.
Maintenance & Warranty
1). Maintenance
Replacing the battery and product maintenance:
a Remove the battery from the unit if it is not required for extended
periods of time in order to avoid damage to the battery
compartment and the electrode resulting from a leaking battery.
b After power on, if a symbol " " appears on the LCD, indicates
that you should replace the battery in order to avoid inaccurate
measuring reading. Otherwise the battery is very possible leak
that will seriously damage the unit life. The battery compartment
is on the down rear of the unit, open the battery door, re place
the old battery for a new 9V one (notice the battery polarity),
close the battery door with a screw knife to lock up.
Cleaning the casing:
Never use alcohol or thinner to clean the unit casing that will especially
erode the LCD surface; just clean the unit lightly as needed with little
clean water. Never impact the unit or used on humidity condition.
Do not store or use the unit in following locations where the unit may be
subject to:
a. Splashes of water or high levels of dust.
b. Air with high salt or sulphur content.
c. Air with other gases or chemical materials.
d. High temperature or humidity (above50℃, 90%) or direct sunlight.
2). Warranty:
About relative warranties please read provided warranty card.
We disclaims any liability due to: transportation damages; incorrect use
or operation; manipulation, alterations or repair attempts; without
warranty card, invoice.
Specific Declarations:
a The prod u ct design and the manual updating, repairing by
technician authorized by us, do not try any alternations or repair
attempts.
b Dispose of battery should in accordance with local laws and
regulations.
c If in data communication, the interrupt connection, cause the
user data loss or system to restart and therefore cause other
problems, has nothing to do with our company.
Above picture and content just for your reference. Please be subject to the
actual products if anything different or updated. Please pardon for not
informing in advance.