Loading ...
Loading ...
Loading ...
Setting Surface Controls
Eachburner lights automatically from an electric ignitor each time a control knob isturned to
the lite position.
To operate the surface burner:
1. Placecooking utensil on burner.
2. Push in and turn the Surface Control knob to LITE.Note: All electronic ignitors will click
at the same time. However, only the burner you are turning on will ignite.
3. Visually check that the burner has lit.
4. After the burner lights, turn the control knob to the desired flame size.The control knobs
do not have to be set at a particular mark. Usethe guides and adjust the flame asneeded.
DO NOT cook with the control knob in the LITE position. (The electronic ignitor will
continue to click if left in the LITEposition.)
5. Toturn the burner off, turn the control knob asfar as it ill go, to the OFFposition.
The surface control knobs
shown below may not look iden-
tical to the Surface Controls
Knobs on your range; They are
only representational.
In the event of an electrical power outage, the surface burners can be lit manually. To light a
surface burner, hold a lit match to the burner head, then slowly turn the surface control knob to LITE.Usecaution when lighting
surface burners manually.
Surface burner in usewhen an electrical power failure occurs will continue to operate normally.
Do not operate the burner for an extended period of time without cookware on the grate. The finish on
the grate may chip without cookware to absorb the heat.
Do not place plastic items such as salt and pepper shakers, spoon holders or plastic wrappings on top
of the cooktop when it isin use. These items could melt or ignite. Pot holders, towels or wood spoons could catch fire if placed
too close to a flame.
Before Setting Oven Controls
Oven Vent Location
The oven is vented at the rear of the cooktop. When the oven is on, warm air is released through the vents. This venting is
necessaryfor proper air circulation in the oven and good baking results. DO NOT block the vents. Doing so may cause cooking
failures, fire or damage to the appliance
Arranging Oven Racks
ALWAYSARRANGEOVENRACKSWHEN THEOVENISCOOL(PRIORTOOPERATING
THEOVEN). Always use oven mitts when using the oven.
To remove an oven rack, pull the rack forward until it stops. Lift up front of rack
and slide out.
To replace an oven rack, Fit the rack onto the guides on the oven walls. Tilt the
front of the rack upward and slide the rack back into place.
Setting Oven Controls
Foroven settings, refer to the time or the electronic oven control section.
Loading ...
Loading ...
Loading ...