Loading ...
Loading ...
Loading ...
18
Please note
IThe lter lasts about two months if the appliance is used nor-
mally. If the coee machine is left unused with the lter in-
stalled, it will last a maximum of 3 weeks.
5. "RUN WATER INTO FILTER HOLE" "UNTIL IT COMES OUT" (g.
38): To activate the lter, run tap water through the hole
in the lter as shown in the gure until water comes out
of the openings at the side for more than a minute. Press
;
6. Extract the tank (A17) from the appliance and ll with
water.
7. "IMMERSE FILTER TO" "EXPEL AIR BUBBLES" (g. 39): Insert
the lter in the water tank and immerse it completely for
about ten seconds, sloping it and pressing it lightly to ena-
ble the air bubbles to escape. Press ;
8. "INSERT FILTER" "IN
HOUSING": Insert the l-
ter (D7) in the lter hous-
ing (g. 36) and press
as far as it will go. Press
;
9. "INSERT WATER TANK":
Close the tank with the
lid (A17), then put the
tank back in the machine
(g. 5);
10. "POSITION 0.5L
CONTAINER" "OK TO ENABLE FILTER" (g. 7): Place the
container under the hot water spout (D6) and press
. Delivery begins and stops automatically.
The lter is now active and the coee machine can be used.
16.2 Replacing the lter
Replace the lter (D7) when "REPLACE WATER FILTER" "PRESS
OK TO START" appears on the display: to replace immediately,
press
and follow the instructions from point 5.
To replace the lter later, press
. The sym-
bol appears on the display to remind you that the lter needs
replacing. To replace, proceed as follows:
1. Extract the tank (A17) and exhausted lter;
2. Remove the new lter from the packaging;
3. Access the menu as described in section "6.1 Access the
settings menu";
4. Follow the operations described in the previous section
from point 3.
The lter is now active and the coee machine can be used.
39
Please note!
After two months (see date indicator) or when the appliance has
not been used for 3 weeks, you should replace the lter even if
the message has not yet been displayed.
16.3 Removing the lter
If you want to use the appliance without the lter (D7), you
must remove it and notify the appliance of its removal. Proceed
as follows:
1. Extract the tank (A17) and exhausted lter;
2. Access the menu as described in section "6.1 Access the
settings menu";
3. PRESS "WATER FILTER";
4. Press the selector corresponding to " REMOVE WATER
FILTER";
5. "CONFIRM FILTER REMOVAL": press
(or
press
to go back to the settings menu);
6. "FILTER REMOVED": the change has been saved. Press
to go back to the homepage.
Please note!
After two months (see date indicator) or when the appliance has
not been used for 3 weeks, you should replace the lter even if
the message has not yet been displayed.
17. TECHNICAL DATA
Voltage: 220-240 V~ 50-60 Hz max. 10 A
Power: 1450 W
Pressure: 1.9 MPa (19 bars)
Water tank capacity: 1.8 l
Size LxHxD: 240x440x360 mm
Cord length: 1750 mm
Weight: 10 kg
Beans container capacity: 300 g
Frequency: 2400/2483.5 MHz
Maximum transmission power 10 mW
Loading ...
Loading ...
Loading ...