Loading ...
Loading ...
Loading ...
To receive firmware updates for the cooking hob, you need to be
paired to the cooking hob via the mobile app. You will receive a
notification, or you can check available firmware updates on the
mobile app menu for updates.
FoA - Firmware update over
the air
Firmware update via Wi-Fi
In order to start the firmware update via the mobile app, set this setting
to on to confirm your presence at the cooking hob. For more
information, see chapter "Wi-Fi Connection setup". After 10 min, this
setting is automatically reset to off.
If your electrical wiring or circuit breakers do not meet the specified
current draw on the rating plate, the current limiter can be activated
by reducing the value of this setting. Doing so may cause a reduced
performance of the induction hob.
Con - Connection power
Current limiter
(connection to power grid)
The following numbering format of the setting is available: X.XX.
The number left of the dot represents the number of connected
phases, while the number right of the dot represents the electrical
current per phase in Ampere.
NOTE!
To prevent unintentional adjustment of the 'Con - connected
power', Con setting must be confirmed when changed by touching
the slider for 3 seconds. A change without confirmation will not
be implemented!
WARNING!
The appliance must always be set to the actual or lower rating of
the electrical wiring or circuit breakers. This setting can only be
set by an authorised expert.
Resets to default settings.rES - Factory reset
Factory reset
In demo mode, the appliance will act as usual, without the possibility
to heat the cookware.
dE - Demo mode
Demo Mode for Dealer
Showrooms When set, this will be indicated after switching on the appliance with
a short "d" indication.
Without any user interaction, the appliance will automatically switch
off after 10 minutes.
Table continued from last page
47
Settings
Loading ...
Loading ...
Loading ...