Loading ...
Loading ...
Loading ...
12
SET-UP
6. Perform one of the following to connect the flex shaft to the
chute control rod coupling:
• Models with Overhead Rotational - Insert hex end of flex
shaft into chute control rod coupling under handle panel
(Figure 30).
Figure 30
• Models with Electric Chute Control - Insert other end of
flex shaft into chute control rod coupling under handle
panel. Make sure to line up flat end of rod and flat end of
coupler. You may need to rotate rod around until these
two surfaces line up (Figure 31 inset).
Figure 31
Shift Rod (if Equipped)
1. Ensure speed selector is in fastest forward speed.
2. Remove cotter pin (a) and washer (b) from adjustment ferrule
(c) on shift rod (d) and pull it out from shift lever (e)
(Figure 32 inset).
a
e
c
b
d
f
Figure 32
3. Make sure the shift lever on the back of the transmission is
rotated downward to the full extent of its rotation see Figure
33, Detail “A” for models without hydro transmission or Detail
“B” for models with hydro transmission.
Hydro Models
B
Non-Hydro Models
A
Figure 33
4. If necessary, loosen the jam nut (f) and rotate the ferrule
up or down on the shift rod until the ferrule aligns with the
upper hole in the shift lever (Figure 32). Tighten jam nut.
5. Insert ferrule into top hole of shift lever and secure with
cotter pin (a) and washer (b) removed in Step 2.
STOP
Continue to Set-Up (page 14).
OVERHEAD CHUTE ROTATION CONTROL W/
4WAY ELECTRIC PITCH & ROTATION CONTROL
Chute Control Rod
or
Manual Chute
Control Rod
Chute Assembly
Figure 34
NOTE: If equipped with a metal chute
assembly - This assembly will install the
same as the standard chute shown in the
figures of this procedure.
Loading ...
Loading ...
Loading ...