Loading ...
Loading ...
Loading ...
• Replace the damaged parts.
• Tighten the bolts.
• If needed, call the customer service phone
number (enter number here) for servicing
instructions.
• Store the machine in a dry, isolated and frost-free
area.
14 TROUBLESHOOTING
PROBLEM POSSIBLE
CAUSE
SOLUTION
The motor does
not start.
The power but-
ton is in the
"OFF" (O) posi-
tion.
Set the power
switch to the
“ON” ( | ) posi-
tion.
The power cord
is not plugged in.
Connect the
power cord to
the power sup-
ply.
Electrical outlet
does not supply
sufficient power.
Try another elec-
trical outlet.
The circuit
breaker is trip-
ped.
Let it cool, and
start the ma-
chine again.
The power
switch is on, but
you do not pull
the spray gun
trigger.
Pull the spray
gun trigger.
The machine
does not reach
high pressure.
The diameter of
garden hose is
too small.
Replace with a
1” (25 mm) or
5/8” (16 mm)
garden hose.
Water supply is
restricted.
Check garden
hose for kinks,
leaks, and block-
age.
The water supply
is not sufficient.
Open the water
supply fully.
Spray tip has not
be installed onto
the spray wand
properly.
Install desired
spray tip to end
of wand.
The water intake
filter is clogged.
Remove filter
and rinse in
warm water.
PROBLEM POSSIBLE
CAUSE
SOLUTION
The output pres-
sure varies high
and low.
The water supply
is not sufficient.
Open water sup-
ply fully. Check
garden hose for
kinks, leaks, or
blockage.
The pump is
drawing in air.
1. Make sure
that the ho-
ses and fit-
ting are air-
tight.
2. Turn "OFF"
machine.
3. Purge pump
by squeezing
trigger gun
until a steady
flow of water
comes out
the spray tip.
The water intake
filter is clogged.
Remove the filter
and Rinse in
warm water.
The supply volt-
age is low.
Make sure that
only the pres-
sure washer is
running on the
circuit.
The gun, hose or
nozzle are calci-
fied.
Run distilled vin-
egar through de-
tergent tank.
13
English
EN
Loading ...
Loading ...
Loading ...