Loading ...
Loading ...
Loading ...
TO SIPHON CHEMICALS/CLEANING SOLVENTS
Siphoning chemicals or cleaning solvents is a low pressure operation.
NOTE: Use only soaps and chemicals designed for pressure washer use. Do not
use bleach.
1. Press chemical hose onto barbed fitting located
near high pressure hose connection of pump as
shown.
2. Place other end of chemical hose with filter on it
into container holding chemical/cleaning solution.
3. Install low pressure (black) nozzle into quick
connect fitting of wand, see How To Use Wand
paragraph in this section.
4. After use of chemical, siphon clean water through
chemical hose to rinse it and pump clean.
Chemicals which remain in pump can damage it. Damage to pump due to
chemicals will not be covered under warranty.
NOTE: Chemicals and soap will not siphon when wand is in the high pressure
setting.
READ AND UNDERSTAND ALL WARNINGS BEFORE STARTING UNIT
When using the high pressure setting DO NOT allow the
high pressure spray to come in contact with unprotected skin.
eyes. or with any pets or animals. Serious injury can occur,
Your washer operates at fluid pressures and velocities high eeough to penetrate
human and animal flesh, which could result in amputation or other serious injury.
Leaks caused by loose fittings or worn or damaged hoses can result in injection
injuries. DO NOT TREAT FLUID INJECTION AS A SIMPLE CUT! See a
physician immediately!
Never fill fuel tank when engine is running or hot. Do not
smoke when filling fuel tank.
Never fill fuel tank completely. Fill tank to 1/2 below bottom of filler neck to
provide space for fuel expansion. Wipe any fuel spillage from engine and
equipment before starting engine.
Never run engine indoors or in enclosed, poorly ventilated areas, Engine
exhaust contains carbon monoxide, an ododess and deadly gas.
DO NOT let hoses come in contact with very hot engine muffler during or
_tely after use of your pressure washer. Damage to hoses from contact
with hot engine surfaces will NOT be covered by warranty.
Never pull water supply hose to move pressure washer. This
could damage hose and/or pump inlet.
DO NOT use hot water, use cold water only.
Never turn water supply off while pressure washer engine is running or oamage
re pump will result.
DO NOT stop spraying water for more than two minutes at a time. Pump
operates =n bypass mode when spray gun trigger is not pressed. If pump is left
in bypass mode for more than two minutes internal components of the pump
can be damaged.
If you do not understand these precautions please call 1-888-559-8550 to
speak to a service representative for further instructions.
11_ ENG D25803
Loading ...
Loading ...
Loading ...