Loading ...
Loading ...
Loading ...
6
3 CHANNEL STEREO & BRIDGED MONO MODE
INPUTS
• When using 1 set of RCA inputs to run the 3 channels, you only need to use INPUT Channels 3+4.
Then switch the “2IN 4IN” switch to “2IN”
• If using 2 sets of RCA inputs to run this configuration, you will switch the “2IN 4IN” switch to “4IN”
NORMAL/BRIDGED
• Set switch to “NORM”
SLOPE
• Using the “SLOPE” switch on the top, select 12db for your crossover slope.
CHANNELS 1 & 2 CROSSOVER CONFIGURATION
• Channels 1+2 will be your HP Stereo channels.
• Adjust Channel 1+2 HP control to approximately 120Hz.
CHANNELS 3 & 4 CROSSOVER CONFIGURATION
• Channels 3+4 will be your LP Mono subwoofer channels
• Adjust Channel 3+4 LP control to approximately 120Hz.
• Adjust Channel 3+4 HP control to 10hz, unless you would like subsonic filter on your subwoofer.
In this case, you can adjust the control within the 20-30hz range.
GAIN CONTROL
• You will be using the “LEVEL 1+2” for your HP Stereo channels 1+2
• You will be using the “LEVEL 3+4” gain control for your LP Mono Subwoofer Channels
SPEAKER OUTPUTS
• Following the wiring diagram on the last page, wire your speakers to the appropriate output wires,
respecting the channels, and the + and – phasing. See 4B.
Loading ...
Loading ...
Loading ...