Loading ...
Loading ...
Loading ...
4
2 CHANNEL BRIDGED STEREO MODE
INPUTS
• You only need to use Rear INPUT Channels 3+4.
NORMAL/BRIDGED
• Set switch to “BRIDGED”
SLOPE
• Using the “SLOPE” switch on the top, select 12db for your crossover slope.
CHANNELS 3 & 4 CROSSOVER CONFIGURATION
• To adjust the crossovers, you will be looking at the controls on the top row. You will be able to choose
from Full Range (FR), High Pass (HP), Low Pass (LP), and Band Pass (BP)
• For FR, set MODE switch to HP, and adjust the HP control down to 10hz.
• For HP, set the MODE switch to HP, and adjust the HP control to set the HP frequency.
• For LP, set the MODE switch to LP. Adjust the HP control down to 10hz. Then adjust LP control to set
the LP frequency.
• For BP, set the MODE switch to LP, and adjust the LP control to the desired LP frequency. Adjust the
HP control to set HP frequency.
• Motorcycles normally use HP 120Hz.
GAIN CONTROL
• In this mode you will be using the “LEVEL 3+4” gain control to match your sources output level to
your amplifiers input.
SPEAKER OUTPUTS
• Following the wiring diagram in Figure 3B, wire your speakers to the appropriate output wires,
respecting the channels, and the + and – phasing.
Loading ...
Loading ...
Loading ...