Loading ...
Loading ...
Loading ...
13
BEFORE SETTING SURFACE CONTROLS
BEFORE SETTING SURFACE CONTROLS
Assembly of the Burner Caps
Make sure that all of the surface burner caps and
surface burner grates are installed correctly and at
the correct locations.
Remove all packing material from the cooktop area.
Make sure burner head and caps are properly
placed on the surface burners. The round burner
heads have a hole which fits over the ignitor. Make
sure the head fits snugly before placing the burner
caps.
The two oval burners in the center of the cooktop
are sealed burners. Unlike the round burners, these
burner heads are attached to the cooktop. The
burner cap should fit snug onto the burner head
and rest level. Refer to Figure 1 for correct and in-
correct burner cap placement.
Unpack the burner grates and position them on the
cooktop after the burner heads and caps are
properly installed.
CAUTION
• Do not allow spills, food, cleaning agents, or
any other material to enter the gas orifice
holder opening.
• Always keep the burner caps and burner
heads in place whenever the surface burners
are in use.
• Never place flammable items on the cooktop.
Once in place, you may check the fit by gently slid-
ing the burner cap from side to side (Figure 1) to
be sure it is centered and firmly seated. When the
burner cap lip makes contact inside the center of
the burner head you will be able to hear the burner
cap click.
IMPORTANT
Please note that the burner cap should not move
o the center of the burner head when sliding
from side to side.
• Check and be sure that all oval-style burner
cap is correctly in place on the burner head.
• Do not use the surface burners without the
burner caps properly installed. Improperly
seated burner caps may prevent burners from
lighting or cause uneven flame and heating.
• Missing pieces or improper installation may
lead to spills, burns, or damage to your range
and cookware.
• Never place flammable items on the cooktop.
Figure 1: Gently move cap for proper placement
The oval burner is dierent from the round
burners. The 3 burner cap placed should be
correctly onto the burner heads. The ignitors are
already set into the burner heads (sealed burners).
Burner caps
Burner
head
burner
cap
burner
head
igniter
orifice
Loading ...
Loading ...
Loading ...