Loading ...
Loading ...
Loading ...
TROUBLE SHOOTING CHART
PROBLEM: The engine will not start.
1. Follow the steps, =How To Start The Engine" in this book.
2. Electric- Start Models: Clean the battery terminals. Tighten the
cables.
3. Drain the fuel tank. Clean the fuel line. Replace the fuel filter.
4. Remove the spark plug(s). Move the throttletothe SLOW posi-
tion. Turn the ignition keytothe ON position. Try to start the en-
gine several times. Install the spark plug.
5. Replacethe sparkplug.
6. Adjust the carburetor.
PROBLEM: The engine will not turn over.
1. Follow the steps, =How To Start The Engine" in this book.
2. Electric- Start Models: Checkthe level ofthe acid inthe battery.
If needed, add water. Charge the battery.
3. Replace the fuse.
4. Check the wiflng harness for damage or a loose connection.
Repair the damaged wire.
5. Electric- Start Models: replace the solenoid. Recoil- Start Mod-
els: replace the module.
PROBLEM: The engine is difficult to start.
1. Adjust the carburetor.
2. Replace the spark plug.
3. Replace the fuel filter.
PROBLEM: The engine does not run smooth or has s
loss of power.
1. Check the oil.
2. Clean the air filter.
3. Clean the air screen.
4. Replace the spark plug.
5. The engine isworking too hard. Use a lower gear.
6. Adjust the carburetor.
7. Replace the fuel filter.
PROBLEM: The engine does not run smooth st fast
speed.
1. Replacethesparkplug.
2. Adjustthethrottlecontrol.
3. Cleantheairfilter.
4. Replacethefuelfilter.
PROBLEM: The engine stops when the blades are
engaged.
1. Toactivatetheseatsensor,alwayssitinthemiddleoftheseat.
2. Checkthe wiringharnessfor damageor a looseconnection.
Repairthedamagedwire.
PROBLEM: On slopes, the engine stops.
1. Mow up and down slopes. Never mow across a slope.
2. To activate the seat sensor, always sit inthe middle ofthe seat.
PROBLEM: The engine will not idle.
1. Replace the spark plug.
2. Clean the air filter.
3. Adjust the carburetor.
4. Adjust the throttle control.
5. Drain the fuel tank. Clean the fuel line. Replace the fuel filter.
PROBLEM: A hot engine causes a decrease in power.
1. Clean the air screen.
2. Check the oil.
3. Adjust the carburetor.
4. Replace the fuel filter.
PROBLEM: Excessive vibration.
1. Replace the blade.
2. Check for loose engine bolts.
3. Decrease the air pressure in the tires.
4. Adjust the carburetor.
5. Check for a damaged belt or damaged pulley. Replace the
damaged parts.
PROBLEM: The grass does not discharge correctly.
1. Stop the engine. Clean the mower housing.
2. Raise the height of cut.
3. Replace or sharpen the blade(s).
4. Move the shift lever to a slower speed.
5. Move the throttle control to the FAST position.
6. Replace the spring for the blade idler.
PROBLEM: The mower housing does not cut level.
1. Check the air pressure in the tires.
2. Adjust the level of the mower housing.
3. Check the front axle. Ifthe front axle does not freely pivot, loos-
en the axle bolt(s).
PROBLEM: The mower blades will not rotate.
1. Check the mower drive belt. Make sure the belt isinstalledcor-
rectly.
2. Replace the mower drive belt.
PROBLEM: The unit will not move when the brake is
released and the speed control pedal Is depressed.
1. Check the motion drive belt. Make sure the belt is installed
correctly.
2. Adjust the clutch.
3. Replace the motion drive belt.
4. Release the Automatic Drive Disconnect under the seat.
PROBLEM: The unit moves slower or stops when the
speed control pedal is depressed.
1. Adjustthe clutch.
2. Replacethemotion drivebelt.
PROBLEM: When the brake pedal is released, belt noise
can be heard.
1. Temporary belt noise does not changethe operation ofthe unit.
If belt noise is continuous, check the routing ofthe belt. Make
sure the belt isinside all belt guides.
2. If the noise is continuous, adjust the clutch.
PROBLEM: The rear wheels spin over uneven terrain.
1. Check the front axle. Ifthe front axle does notfreely pivot, loos-
en the axle bolt(s).
F.98889 31
Loading ...
Loading ...
Loading ...