Loading ...
Loading ...
Loading ...
ASSEMBLY
3.
HOW TO INSTALL THE SEAT
Usa the fasteners shown below to installthe seat. The fasteners are
shown at full size.
Check the operating position ofthe seat. If the seat needs to
be adjusted, loosen the two wing bolts. Slide the seat forward
orbackward along the seat adjusting holes as shown. Tighten
the wing bolts (A).
1.
2.
(A) (a)
94160 17x47Z
Carefully remove the plastic bag from the seat.
Align the holes in the seat hinge to the holes in the seat
(Figure 1). Fasten the seat to the seat hinge withthe fasteners
as shown.
Seat Hinge
Seat
Adjus_ngHole
A
HOW TO ASSEMBLE THE STEERING WHEEL
Fasteners are not required to assemble the steering wheel. Attach
the steering wheel as follows:
1. Make sure the front wheels point forward.
2. Look at the hub of the steering wheel. Make sure the locking
clip is in place Inside the hub.
3. Slide the cover over the steering post (Figure 2).
4. Slide the steering wheel onto the steering post. Push on the
steering wheel. The steering wheel will lock onto the steering
post. Pull onthe steering wheel. Make sure the steering wheel
is locked in place.
5. Some models have an optiona/decal in the parts bag, Attach
the decal to the center of the steering wheel as shown.
SteeringWheel
SteeringPost
Hub
Cover
i Figure 2
HOW TO ASSEMBLE THE GAUGE WHEELS
Use the fasteners shown below to install the gauge wheels. The
fasteners are shown at full size.
1. Attach the gauge wheels to the axle bolts with the fasteners.
NOTE: The axle bolt is mounted inthe LOW position. To change
the position to a higher cutting position, see "How To Adjust
The Gauge Wheels" in the Maintenance section.
1=-98889 10
Axle Bolt
B
A
Figure 3
Loading ...
Loading ...
Loading ...