Loading ...
Loading ...
Loading ...
ASSEMBLY
MAINTENANCE FREE BATTERY HOW TOCHARGE THE MAINTENANCEFREE BATTERY
IMPORTANT: Before you attach the battery cables to the A
battery, check the battery date. The battery date tells if the
&JL
battery must be charged.
1. Check the top ofthe battery for the location of the battery date 1.
(Figure 4).
2. If the battery is put into service before the battery date, the 2.
battery cables can be attached without charging the battery. 3.
See "How To Install The Battery Cables'.
3. If the battery is put into service after the battery date, the
battery must be charged. See =How To Charge The 4.
Maintenance Free Battery".
WARNING: When you charge the battery, do not
smoke. Keep the battery away from any sparks. The
fumes from the battery acid can cause an explosion.
Remove the battery and battery tray.
Remove the protective caps from the battery terminals.
Use a 12 volt battery charger to charge the battery. Charge at
a rate of 6 amperes for one hour. If you do not have a battery
charger, have en authorized service center charge the battery.
Installthe battery end battery tray. Make sure the positive (+)
terminal is on the left side.
HOW TO INSTALL THE BATTERY CABLES
A WARNING: To prevent sparks, fasten the red cable to
the positive (+) terminal before you connect the black
cable.
Usethe fastenersshownbelowtoinstallthebattery cables. The
fastenersareshownatfullsize.
(A)
2X82
1,
2.
3,
(13)
14x79
Remove the protective caps from the battery terminals.
Fasten the red cable tothe positive (+) terminal with the fas-
teners as shown (Figure 4),
Fasten the black cable tothe negative (-) terminalwith the fas-
teners as shown.
I
B
\
Black Cable
PosilJve +)
Term nal
A
BatteryTray
I
Figure4
HOW TO PREPARE THE ENGINE
NOTE: The engine was shipped from the factory filled with oil.
Check the level of the oil. Add oil as needed.
See the enginemanufacturer'sinstructionsforthetypeofgasoline
and oilto use. Beforeyou use the unit,read the informationon
safety,operation,maintenance,andstorage,
WARNING: Follow the engine manufacturer's
instructions for the type of gasoline and oil to use.
A lways use a safety gasoline container. Do not
smoke when adding gasoline to the engine. When
inside an enclosure, do not fill with gasoline. Before
you add gasoline, stop the engine. Let the engine
cool for several minutes.
IMPORTANT: This unit is equipped with an internal combustion
engine and must not be used on or near any unimproved
forest- covered, brush- covered or grass- covered land unless
the engine's exhaust system is equipped with a spark arrester
meeting applicable local or state laws (if any). If a spark
arrester is used, it must be maintained in effective working
order by the operator.
In the State of CalIfornia the above is required by law (Section
4442 of the California Public Resources Code). Other states
may have similar laws. Federal laws apply on federal lands.
See an Authorized Service Center for a spark arrester for the
muffler.
In some areas, local law requires the use of a resistor spark
plug to control the ignition signals. See an Authorized Service
Center for a resistor spark plug for the engine.
IMPORTANT! BEFORE YOU START MOWING
[] Checkthe engine oil.
[] Fill the fuel tank with gasoline.
[_ Check the level of the mower housing.
F-98889
Check the air pressure of the tires.
[_ Attach the battery cables.
11
Loading ...
Loading ...
Loading ...