Loading ...
Loading ...
Loading ...
Page 15
CUTTING LARGE SHEETS
(FIG. 14)
FIG. 14
Large sheets and long boards can sag
or bend, depending on support. If you
attempt to cut without leveling and properly
supporting the piece, the blade will tend to
bind, causing KICKBACK and extra load on
the motor.
Support the panel or board close to the cut.
Be sure to set the depth of the cut so that you
cut through the sheet or board only and not
the table or work bench that is supporting it.
The two-by-fours used to raise and support
the work should be positioned so that the
wide sides support the work and rest on
the table or bench. Do not support the work
with the narrow sides, as this is an unsteady
arrangement. If the sheet or board to be cut
is too large for a table or work bench, use
the supporting two-by-fours on the floor and
secured in place.
OPERATION
MAINTENANCE
1. Inspect the circular saw, the lock-
off button, trigger switch and the
accessories for damage.
2. Check for damaged, missing, or worn
parts.
3. Check for loose screws, misalignment
or binding of moving parts, or any other
condition that may affect the operation.
4. If abnormal vibration or noise occurs,
turn the tool off immediately and have
the problem corrected before further
use.
5. Detach the battery pack before cleaning
or performing any maintenance. Using
compressed air may be the most
effective cleaning method. Always wear
safety goggles when cleaning tools
using compressed air.
WARNING:
• Always wear safety goggles or safety
glasses with side shields during power
tool operations, or when blowing dust.
If operation is dusty, also wear a dust
mask.
• Do not at any time let brake uids,
gasoline, petroleum-based products,
penetrating oils, etc. come in contact
with plastic parts. Chemicals can
damage, weaken or destroy plastic,
which may result in serious personal
injury.
• When servicing, use only identical
replacement parts. The use of any
other parts may create a hazard or
cause damage to the product.
• Use only accessories that are
recommended for this circular saw
by the manufacturer. Accessories
that may be suitable for one tool may
become hazardous when used with
another tool.
• Maintain tools with care. Keep cutting
tools sharp and clean. Properly
maintained tools with sharp cutting
edges are less likely to bind, and are
easier to control.
• To ensure safety and reliability, all
repairs should be performed by a
qualied service technician.
Correct
Incorrect
Loading ...
Loading ...
Loading ...