Loading ...
Loading ...
Loading ...
= ,,,H ,, ,
SERVICE AN
TO REPLACE MOWER BLADE DRIVE BELT
(See Fig. 24)
The mower blade drive belt may be replaced without tools,
Park the tractor on level surface. Engage parking brake.
BELT REMOVAL-
= Remove mower from tractor (See "TO REMOVE
MOWER" in this section of this manual),
o Work belt off both mandrel pulleys and idler pulleys.
o Pull belt away from mower.
BELT INSTALLATION
= Instali new belt in reverse order of removal
,' Make sure belt is inall pulley grooves and inside all belt
guides°
= Install mower in reverse order of removal instructions,,
IDLER
PULLEYS
MANDREL
PULLEY
FIG. 24
MANDREL
TO ADJUST BRAKE (See Fig, 25)
Your tractor is equipped with an adjustable brake system
which is mounted on the right side of the transaxfe,
Iftractor requires more than six (6) feet stopping distance
at high speed inhighest gear, then brake must be adjusted.
o Depress clutch_rake pedal and engage parking brake.
o Measure distance between brake operating arm and
nut "A" on brake rod.
= If distance is other than !-3/4", loosen jam nut and turn
U 1 ti • ' t_ * •
n t A untd distance becomes t-3/4 o Ret ghten jam
nut against nut "A".
• Road test tractor for proper stopping distance as stated
above. Readjust if necessary, If stopping distance is
still greater than six (6) feet in highest gear', further
maintenance is necessary. Contact your nearest au-
thodzed service center_
ADJUSTMENTS
....... t_
WITH PARKING BRAKE
"ENGAGED"
JAM
NUT
OPERATING
ARM
DO NOT TOUCH THIS NUT° tF FURTHER
BRAKE ADJUSTMENT IS NECESSARY,
CONTACT YOUR NEAREST AUTHORIZED
SERVICE CENTER/DEPARTMENT
FIG, 25
TO REPLACE MOTION DRIVE BELT
(See Fig. 26)
Park the tractor on level surface. Engage parking brake.
For assistance, there is a belt installation guide decal on
bottom side of left footrest.
* Remove mower (See "TO REMOVE MOWER" inthis
section of this manual)
o Disconnect clutch wire harness,,
o Remove clutch tocator.
° Remove upper belt keeper,
° Remove belt from stationary idler and clutching idler.
= Pull belt slack toward rear of tractor,. Carefully remove
belt upwards from transmission input pulley and over
cooling fan blades.
= Puff belt toward front of tractor and remove downwards
from around electric clutch.
= install new belt by reversing above procedure.
IMPORTANT: MAKE SURE UPPER BELT KEEPER IS
POSITIONED PROPERLY BETWEEN LOCATOR TABS
AND ELECTRIC CLUTCH WIRE CONNECTION IS
SECURE.
ELECTRIC
CLUTCH ,,- CLUTCHLOCATOR
UPPERBELT"----- _
KEEPER -_"_J__JJ.
LOCATOR/ ",.'_?:_-', [_
TABS
"- _\ I o (]_=,41h\
CLUTCHING""- _ J _ l J
IDLER 3 li
STAT|ONARY"_'_ / I % ]1/
TRANSMISSION'-,. . .,J_.-' ,.1-,
,NPUTPULLEY " 'UTC.
, ,, .-.,,, _ WIRE
HARNESS
22 FiG. 26
Loading ...
Loading ...
Loading ...