Loading ...
Loading ...
Loading ...
ASSEMBLY
..... ___ !lUl II'll ............................,.___ '
Your lawn mower has been assembled at the fac-
tory except for the Grass Catcher Bag and the Grass
Catcher Frame.
TOREMOVELAWNMOWERFROMCARTON
• Cut down the corners of the carton and lay ends
and sides down fiat.
o Remove packing material.
• Lift lawn mower off of shipping base and check
carton thorougly for loose parts.
HOWTOSET-UPYOURLAWNMOWER
TO UNFOLDHANDLE
0 Raise handles until lower handle section locks into
place in mowing position (See Fig. 1).
Raise upper handle section into place on lower
handle, remove protective padding and tighten
both handle knobs.
• Remove handle padding holding operator pres-
ence control bar to upper handle.
- Your lawn mower handle can be adjusted for your
mowing comfort. Refer to "Adjust Handle" in the
Service and Adjustment sectionof this manual.
TO ASSEMBLE GRASS CATCHER
o Put grass catcher frame into grass bag with stiff
part of bag on the bottom.
® Slip vinyl bindings over frame (See Fig. 2).
NOTE: If vinyl bindings are too stiff, hold them in
warm water for a few minutes. If bag gets wet, let
it dry before using.
TO ATTACH GRASS CATCHER
* Lift the rear door on the lawn mower housing and
place the grass catcher frame onto the formed up
tabs on the rear door hinge bracket (See Fig. 3).
The grass catcher is secured to the lawn mower
housing when the rear door is Jowered onto the
grass catcher frame.
OPERATOR PRESENCE
CONTROL BAR
UPPER
LIFT UP
MOWING POSITION
CATCHER FRAME
\
FRAME OPENING
FI6. 2
i Iq u' '1I"'l'lq I
HINGE BRACKET _/ __*_---REAR DOOR
FORME._¢D UP TABS
GRASS
FIO. 3
CAUTION: DO NOT RUN YOURLAWN mOWER
WITHOUTCLIPPINGDEFLECTORORAPPROVED
ORASSCATCHERIN PLACE.NEVERATTEMPTTO
OPERATETHE LAWNmOWER WITH THE REAR
DOOR REMOVEDOR PROPPEDOPEN.
6
Loading ...
Loading ...
Loading ...