Loading ...
Loading ...
Loading ...
T
DRIVEWHEELS ..........
Check Front Drive Wheels each time before you mow
to be sure they move freely.
The Wheels not turning freely means trash, _rass cut-
tings, etc. are in the Drive Wheel area ana must be
cleaned to free Drive Wheels.
If necessary to clean the Drive Wheels, check both
Front Wheels.
Remove Hubcaps, Hairpin Cotters and Washers.
Remove Wheels from Wheel Adjusters.
o Remove any trash or grass cuttings from inside
the Dust Cover, Pinion and/or Drive Wheel Gear
Teeth.
e Put Wheels back in place.
if after deaning, the Drive Wheals do not turn
freely, contact your nearest Sears Service Center.
GRASSCAT(HER
e
e
The Grass Catcher may be hosed with water, but
must be dry when used.
Check your Grass Catcher often for damage or
deterioration. Through normal use it wiJJ wear.
Jf Catcher needs replacing, replace only with a
manufacturer approved replacement Catcher
from Sears. Give the lawn mower model number
when ordering.
EN61NE
TO CHANGEOiL (WARM OIL DRAINS BETTER)
1
CAUTION: D|SCONNEa SPARKPLUGWIREFROM|
SPARKPLUGAND PLACEWIREWHEREIT CANNOT|
COME IN CONTACTWITH SPARKPLUG.
o Remove Engine Oil Cap; lay aside on a clean
surfa ce.
Tip lawn mower on its side as shown in Fig. t 1
and drain oil into suitable container. Rock Iawn
mower back and forth to remove any oil trapped
inside of engine.
® Wipe off any spilled oi! on lawn mower and on
side of engine.
Fill engine with SAE 30 or 10W 30 OiL Fil! only
to the "FULL" line on the dipstick. DO NOT
overfill.
Replace Engine Oi! Cap.
• Reconnect Spark Plug Wire to Spark Plug.
CONTAINER
/
/
SLOT
JNTER,,
CLOCKWISE
TO REMOVE
TAB
AiR FILTER TURN CLOCKVvqSE
TIGHTEN
AIR FILTER COVER
FiG. !2
AIR FILTER
Your engine will not run properly and may be
damaged by using a dirty Air Filter.
Replace the Air Filter every year, more often if you
mow in very dusty, dirty conditions. Do not wash Air
Filter.
TO CHANGE AIR FILTER
e Remove the Air Filter Cover by turning counter-
clockwise to the stop and pull away from Collar
(See Fig. !2).
Remove Filter from inside of Cover (See Fig. 12).
• Clean the inside of the Cover and the Collar to
remove any dirt accumulation.
® Insert new Filter into Cover.
Put Air Filter Cover and Filter into Collar align-
ing the Tab with the Slot.
Push in on Cover and turn clockwise to tighten
(See Fig. 12).
12
Loading ...
Loading ...
Loading ...