Loading ...
Loading ...
Loading ...
Owner’s Manual for Portable Generator 5
Assembly
Unpacking
• Remove all packaging material.
• Remove separate accessory kit box.
• Remove generator from carton.
Accessories
Check contents against the list in Table -1. If any parts
are missing or damaged, or if any problems occur during
assembly, call the Generator Helpline at 1-888-431-6871.
Table -1. Contents
Install Accessory Kits
The generator requires some minor assembly before
use.
Tools Required
Obtain the following tools:
• Two 8mm, 10mm, 12mm and 13mm box wrenches
Install Wheel Kit (If Equipped)
The wheels are specially designed to enhance portability.
The wheels are not intended for over-
the-road use.
1. Slide M6 bolt (M) through holes in frame rail. Install into axle
bracket (L).
2. Slide axle (D) through axle bracket (L), wheel (A), and into
½” flat washer (G). Insert hair pin (F) through axle (D).
Install frame foot and rubber bumpers.
1. Slide rubber foot (E) through frame foot (B). Install locking
flange nuts (K).
2. Slide M8 bolt (J) through holes in frame rail. Slide frame foot
(B) onto M8 bolts. Install locking flange nuts (K).
Install Handle
1. Slide M8 carriage bolt (H) through handle bracket and han-
dle assembly (C) by first inserting the bolt through the
square hole in the handle assembly (C).
2. Install M8 flange nut (K).
Battery Replacement/Connection
The battery shipped with the generator
has been fully charged. A battery may
lose some charge when not in use for prolonged periods
of time. If battery is unable to crank engine, plug in the
12V charger included in the accessory box (see
Charging the Battery (electric start units only)
IMPORTANT: Running the generator does not charge
battery.
Accidental Start-up. Disconnect the
negative battery cable, then the posi-
tive battery cable when working on unit. Failure to do so
could result in death or serious injury.
Item Qty.
Generator 1
Owner’s Manual 1
Product Registration Card
(English, Spanish, and French)
3
Service and Emissions Warranty 1
Liter SAE 30 Oil 1
Battery Charger (electric start models) 1
Wheel (A) 2
Frame Foot (B) 2
Handle Assembly (C) 1
Axle (D) 1
Hardware Bag
Rubber Foot (E) 2
Hair Pin (F) 2
1/2” Flat Washer (G) 2
M8 Carriage Bolt (H) 2
M8 Bolt (long) (J) 4
M8 Hex Flange Nut (K) 8
Axle Bracket (L) 2
M6 bolt (M) 4
NOTICE:
000757
B
A
C
D
E
F
G
L
K
M
H
K
J
NOTICE:
WARNING
Loading ...
Loading ...
Loading ...