Loading ...
Loading ...
Loading ...
14
INTEGRATED PANEL INSTALLATION
Panel Installation
MLNP115-IS01A & M
P
NP415-IS81A
3/4" (20 mm) panel
14
1
" (379 mm) width
30" (762 mm) height
1. Fully open door.
2. Starting at corner, pull gasket
away from door.
3. Continue to pull gasket free from
gasket channel.
4. Upon removal, lay gasket down on a flat surface.
5. Align top of panel with top edge of door. Center panel
on door.
Due to differences in floor construction or surrounding
cabinetry, the panel may not sit flush with the top of the
door.
6. Secure integrated panel to door
using clamps. A robust tape may
also be used. Marvel recommends
the use of bar clamps to secure the
panel to the door. If using tape, be
certain the tape will not damage
panel finish upon removal.
7. Using a 7/64” (3 mm) drill bit, drill 6
pilot holes into the wood panel 1/2”
(12 mm) deep using the holes in the
door frame as a guide.
It is important to ensure that all drilled holes are drilled to
the correct depth in order to avoid splits in the wood when
hardwood is installed.
8. Locate 6 of the #6x 1-1/2” (38 mm) screws provided
with your unit.
9. Using a Phillips screwdriver, place one screw into each
of the 6 pilot holes and screw down. Do not over-
tighten screws.
10. Ensure the screws sit flush against the bottom of the
channel.
11. Remove clamps from door.
If panel requires additional adjustment after removing
clamps, slightly loosen each screw and adjust panel as
necessary. Tighten screws upon completion.
12. Starting at the corners, re-install the gasket into the
gasket channel in the frame. Make sure the gasket is
fully seated.
Figure 36
Figure 37
NOTE
NOTE
Figure 38
NOTE
Loading ...
Loading ...
Loading ...