Loading ...
Loading ...
Loading ...
DOOR REVERSAL
Prepare door for reinstallation:
1. Remove gasket. This will reveal mounting holes for the
magnet assembly.
2. Remove magnet assembly from door with T-10 TORX
driver. Be sure to only remove the two screws holding
the assembly to the door. Reinstall on the opposite end
of the door.
3. Rotate gasket 180°, aligning notch with magnet assem-
bly and pressing firmly into the gasket channel starting
at the corners.
4. Rotate door 180° to reverse.
Install top hinge and door:
1. Install hinge with longer straight edge aligned to outside
edge of cabinet. Do not tighten.
2. Lift the door on to the bottom hinge.
3. Align edge of the hinge with the outer edge of the unit.
4. Tighten three hinge screws.
Figure 30
NOTE
REVERSING THE DOOR
1. Open door.
2. Using T-25 Torx bit loosen screw #1 and remove
screw #2 on top and bottom hinge. Slide and remove
the door from the unit.
One hinge includes a metal spacer. Spacer must be
used with that hinge when reversing the door.
3. Remove caps from screw heads on opposite side
(2 on top and 2 on bottom). Using #2 Phillips bit,
remove the 4 underlying screws. Reinstall the
screws and caps on the opposite side.
4. Partially install screw #1 in the outer most holes on
top and bottom. Rotate door 180
o
, align hinge over
screw #1 and slide/seat into position. Reinstall screw
#2 on top and bottom. Tighten both screws and
install hinge cover.
Align and adjust the door:
Align and adjust the door (see DOOR ALIGNMENT AND
ADJUSTMENT).
2
1
Figure 29
12
Loading ...
Loading ...
Loading ...