Loading ...
Loading ...
Loading ...
[-_ INSTALLINGTHE ANTI-TIP DEVICE
WARNING:
• Range MUST be secured with an
approved Anti-Tip device.
• Unless properly installed, the range could
be tipped by you or a child standing, sitting
or leaning on an open door.
• After installing the Anti-Tip device, verify
that it is in place by careflflly attempting to
tilt the range forward.
• This range has been designed to meet all
recognized industry tip standards for all
normal conditions.
• The use of this device does not preclude
tipping of the range when not properly
installed.
• If the Anti-Tip device supplied with the
range does not fit this application, use the
universal Anti-Tip device WB02X7909.
1. Mark the wall where the RIGHT EDGE of the
range is to be located. Be sure to allow for the
countertop overhang if you intend to install the
range next to cabinets.
I
_1 Anti Tip
Silted _ _,_-_ 1
sorew _-"_ dJl
,_ _ J Wallplate I
20°' .. I
"_ ,,,_,, s,, ,_ Marked edge
J _[ YS-- J of range
2. Locate the outside edge of the device 2V8"
toward the center of the range from the marked
edge of the range.
3. Using the device as a template, mark the
position of the hole for the screw.
4. For wood construction, drill a pilot hole at an
angle of 20 degrees from the horizontal. A nail
or awl may be used if a drill is not available.
Mount the Anti-Tip device with the screw
provided.
For cement or concrete construction, you
will need a 1/4" x 1F/' lag bolt and a 1/2" O.D.
sleeve anchor, which are not provided. Drill
the recommended size hole for the hardware.
Install the sleeve anchor into the drilled hole
and then install the lag bolt through the device.
The bolts must be properly tightened as
recommended for the hardware.
Wallboard
Anti-Tip
device
Wood screw
Back of
range
5. Slide the range against the wall, and check
for proper installation by grasping the fi'ont edge
of the cooktop and careflflly attempting to tilt the
range forward.
WHEN ALL HOOKUPSARE COMPLETED:
MAKE SUREALL CONTROLSARELEFTIN THE
OFF POSITION.
MAKE SURETHE FLOW OFCOMBUSTIONAND
VENTILATIONAIRTOTHERANGEIS UNOBSTRUCTED.
CONVERTING TO LP GAS
(or converting back to natural gas from LP)
This range leaves the factory set for use with
natural gas. If you want to convert to LP gas, the
conversion must be performed by a qualified LP
gas installer.
The conversion instructions, sticker and LP
orifices can be found attached to the range next
to the pressure regulator.
There is a second set of instructions included in
the envelope containing the product wiring
diagrams on the back of the range. Keep these
instructions and the orifices in case you want to
convert back to natural gas.
39
Loading ...
Loading ...
Loading ...