Loading ...
Loading ...
Loading ...
CARE AND CLEANING
(continued)
CAUTION: DO NOT OPERATE THE BURNER WITHOUT ALL BURNER PARTS AND DRIP PANS
(IF SO EQUIPPED) IN PLACE.
Sealed Burner Assemblies (onsomemodels) Burner Heads (on sealed burners only)
Grate
Burner cap
Drip pan
(on some models)
Burner head
Electrode
Turn all controls OFF before removing the
burner parts and drip pans (if so equipped).
The burner grates, caps, burner heads and drip
pans (if so equipped) can be lifted off, making them
easy to clean.
The electrode of
the spark igniter is Electrode
exposed when the "\
burner head is
removed. When one
burner is turned to LITE, all the burners spark.
Do not attempt to disassemble or clean around
any burner while another burner is on. An electric
shock may result, which could cause you to
knock over hot cookware.
For proper ignition, make sure the small hole in the
section that fits over the electrode is kept open. A
sewing needle or wire twist-tie works well to unclog it.
The slits in the burner heads of your range must
be kept clean at all times for an even, unhampered
flame.
You should clean the surface burners routinely,
especially after bad spillovers, which could clog
these openings.
To remove burned-on food, soak the burner heads
in a solution of mild liquid detergent and hot water
for 20-30 minutes. For more stubborn stains, use a
toothbrush.
Before putting the burner head back, shake out
excess water and then dry it thoroughly by setting
it in a warm oven for 30 minutes.
Replace the burner caps. Make sure that caps are
replaced on the correct size bnrner. There is one
small, 2 medium and one large cap. (NOTE: On
some models the caps are all the same size and
can be used in any of the 4 needed locations.)
Burner Caps (on sealed burners only)
Lift off when cool. Wash burner caps in hot, soapy
water and rinse with clean water. You may scour with
a plastic scouring pad to remove burned-on food
particles.
Dry them in a warm oven or with a cloth--don't
reassemble them wet. Replace the burner caps.
Make sure that caps are replaced on the correct size
burner. There is one small, 2 medium and one large
cap. (NOTE: On some models the caps are all the
same size and can be used in any of the 4 needed
locations.)
22
small
medium _Q
large
medium _
medium _--
u
Front of Range
m small
large
Loading ...
Loading ...
Loading ...