Loading ...
Loading ...
Loading ...
BR N
QP3 SERIES
iNSTALL THE HOOD
_ ARNING
To reduce the risk of electrical shock, switch power off
at service panel. Lock or tag service panel to prevent
power from being switched on accidentally.
ELECTRICAL
WIRING BOX
COVER
ELECTRICAL
POWER
CABLE
KNOCKOUT
J
[_ Remove Electrical Wiring Box Cover from inside
of hood and appropriate Electrical Power Cable
Knockout from top or back of hood.
Page 8
CONNECT THE WIRING
GROUND
SCREW
HOUSE
POWER CABLE
Connect House Power Cable to range hood wiring -
BLACK to BLACK, WHITE to WHITE, and GREEN or
BARE WIRE to Ground Screw. Replace electrical wiring
box cover.
Re-attach Bottom Pan with 6 Screws removed in Step 10.
DUCTED INSTALLATION ONLY:
Re-install aluminum filters removed in Step 9.
NON-DUCTED iNSTALLATION ONLY:
Install aluminum filters and non-ducted filters - purchased
and assembled in Step 15.
HOUSE
POWER CABLE
El Run House Power Cable between service and hood
panel
location. Attach power cable to hood using appropriate clamp.
Hang hood from (4) mounting screws driven into
part-way
cabinet locations (shown in illustrationsunder "PREPARE
HOOD LOCATION"). Mounting screws are included in parts
bag. Slide hood back towards wall until mounting screw
heads are engaged in narrow end of keyhole slots in top of
hood. Tighten screws securely. Add 5th mounting screw in
center hole in hood and tighten securely.
DUCTED INSTALLATION ONLY:
Connect ductwork to hood and use duct tape to make joints
secure and air-tight. Make sure the damper/duct connector
enters the ductwork and that the damper opens and closes
freely.
Loading ...
Loading ...
Loading ...