Loading ...
Loading ...
Loading ...
Installation instructions en
19
4.
To protect against scratches, position a spacer on
the appliance and place the frame cover on top of
it.
5.
Thread the cables through the openings of the
frame cover.
6.
ATTENTION!
There is a risk of damage to the appliance if the
cable is coiled up.
▶ Always secure the cable firmly using the strain
relief so that it does not coil up fully in the appli-
ance.
Thread the cable on the appliance through the
opening in the frame cover and use the strain relief
supplied to secure it.
7.
Undo the strain relief on the cable on the appliance
and pull out the cable.
8.
Remove the strain relief fitted at the factory.
Put the strain relief to one side.
9.
Thread the four cables into the cable tensioner and
apply equal tension.
Do not shorten the cables.
10.
Readjust the cables. To do this, relieve the load on
the appliance, loosen the cable tensioner and push
the cables up.
11.
Thread the four enclosed cable clamps and secure
in place approx. 20 mm in front of the cable ten-
sioner.
20 mm
2
Tighten the screws by hand.
12.
Align the appliance using a spirit level.
13.
Remove the protective film from the appliance.
Loading ...
Loading ...
Loading ...