ION100V-21SB-CT-RM OPERATOR’S MANUAL

Loading ...

When to Charge the iON100V Lithium-

iON Batteries

NOTE: The iON100V-2.5AMP and iON100V-5AMP lithium-ion

battery packs do not develop a "memory" when charged after

only a partial discharge. Therefore, it is not necessary to run

down the battery pack before placing it into the charger.

• Usethebatterychargeindicatorlightstodeterminewhento

charge your iON100V-2.5AMP and iON100V-5AMP lithium-

ion battery packs.

• Youcan"top-o"yourbatterypack'schargebeforestarting

abigjoborafteralongdayofuse.

Charging the Battery Packs

1. Flip open the battery compartment cover, push the battery

releasing button to release the battery pack(s). Pull the

battery pack(s) out of the equipment. (Fig. 4).

2. Check that the mains voltage is the same as that marked

on the rating plate of the battery charger. Then, insert the

charger's plug into the electrical wall outlet. When you

plug in the charger, the red light will illuminate steadily

(Fig. 5).

mCAUTION! Charger iON100V-RCH is rated for 100 –

120 volt AC only. DO NOT plug the charger into any outlet that

will provide power with a higher voltage. Over voltage charging

will be harmful to both the battery and charger, and may cause

the charger to burn out.

3. Place the battery pack into the charger by sliding the

pack as shown until it clicks into the position. When the

battery is inserted properly, the green light will slowly

ashto indicate that the battery is charging. The red light

willturno.Youwillalsohearafansound(Fig.6).

4. When the green light stays on, the battery is fully charged

(Fig. 6).

Fig. 4

Battery compartment

cover

Battery releasing

buttons

Fig. 5

Red

Fig. 6

Charging Fully Charged

Slowlyashgreen

Green

Loading ...

OPERATOR’S MANUAL - Page 11