Loading ...
Loading ...
Loading ...
17
Hook function (inner edge (11)):
– Pull the tape (10) out of the adapter by the contact edge (11) and turn
the handle by 90° to the left. Place the handle on an edge to hook the
handle on the edge (Fig. 7).
The visible length of tape (between the blue marking on the exit of the
tape on the adapter housing of the adapter and the blue marked inner
edge of the handle) corresponds to the measurement length (in inch).
Press the measuring button (1) to save the measured value. The current
measured value (a) is shown on the bottom line of the display. Press the
measuring button (1) again to start a new measurement.
The current measured value (a)is shown on the bottom line of the display,
while the previous measured value (b) is saved and shown on the top line
of the display.
Note: When switching off the measuring tool, the current measured value
(a) is reset to "0", even if the tape is still pulled out. To avoid measuring er-
rors, always retract the tape fully before taking a new measurement. Do not
press the measuring button until you have done this.
If the tape is already extended when you are fitting the adapter to the meas-
uring tool or switching on the measuring tool, the "roll in" indicator will ap-
pear on the display. Retract the tape fully and press the measuring button
before taking a new measurement.
u Always make sure that the measuring tape does not snap back into
the adapter. Release the tape slowly back into the adapter; otherwise
it may become damaged.
''
3
Z
L
a
s
e
r
M
e
a
s
u
r
e
r
Fig. 7
2610067140 3Z Laser Measurer 02-21.qxp_Layout 1 2/24/21 8:01 AM Page 1
Loading ...
Loading ...
Loading ...