Westinghouse WFE912SA 90cm Freestanding Dual Fuel Oven/Stove

USER MANUAL - Page 43

For WFE912SA. Also, The document are for others Westinghouse models: WFE914SA, WFE916SA, WFE946SA, WVE916SA

PDF File Manual, 48 pages, Read Online | Download pdf file

Loading ...
Loading ...
Loading ...
43
INSTALLATION
WIRING REQUIREMENTS
ThecookerMUSTbeinstalledincompliancewith:
•wiringconnectionsinAS/NZS3000WiringRules
•localregulations,municipalbuildingcodesandother
statutoryregulations
For New Zealand Only:
Thecookingrangemustbeconnectedtothesupplyby
asupplycordfittedwiththeappropriatelyratedplug
thatiscompatiblewiththesocket-outletfittedtothefinal
sub-circuitinthefixedwiringthatisintendedtosupply
thiscookingrange.
Supplycordsizerequired
WFE912/WFE914/WFE916/WVE9161.5mm
2

WFE9466.0mm
2
•AfunctionalswitchMUSTbeprovidednearthe
applianceinanaccessibleposition(AS/NZS3000
-Clause4.7.1).
•WiringMUSTbeprotectedagainstmechanicalfailure
(AS/NZS3000-Clause3.9).
•Thecookerrequiresameansofallpoledisconnection
incorporatedintothefixedwiring.ThisMUSThavea
disconnectiongapof3mm.
•ThecookerMUSTbeproperlyearthed.
NOTE : When connections are made to a multi-phase
230/240V supply, the bridge piece MUST be
removed from between the active connections.
TIPS & INFORMA
TION
BEFORE YOU COOK IN YOUR NEW OVEN IT IS IMPORTANT
THAT THE PROTECTIVE OILS USED IN THE MANUFACTURE OF THE
PRODUCT BE REMOVED.
•Makesurethattheroomiswellventilated(toallow
smoketoescape).
•Runthegrillonhighfor30minuteswithoutgrilldish.
•Thenruntheovenon220°Cfor1hour.
CONNECTING TO SERVICES AND COMMISSIONING
Thisappliancemustbeinstalledbyanauthorisedperson,
accordingtoallcodesandregulationsof:
•Electricalsupplyauthorities.
•Buildingregulations
•Localgovernmentandcouncilauthorities.
•AS/NZS5601.1(particularattentionto6.10.1and
figure6.3,andclause6.10.1.11).
•AS/NZS3000(particularattentiontoclause4.3.11
andclause3.9).
HARD WIRING DETAIL
1.Removeterminalcoverplatefromrearpanelof
appliance.
2.Fitwiresthroughholeincoverplateandmake
connectionstoterminals.
3.Engagewiresintoplasticclip.Secureplasticclipwith
twolongsilverscrews(suppliedinseparatebag).
4.Replacecoverplateontorearpanel.
Dataplategivesinformationaboutrating
islocatedbehindthebottomofthe
ovendoor
Circuitdiagramislocatedonthebackpanelofthe
appliance
ELECTRICAL CONNECTION LOCATION - MODEL WVE916
Entrypointofelectricalcable
99
113
Securingpoints
Plasticclips
Plasticclip
Loading ...
Loading ...
Loading ...