Ancona AN1258 User Manual

Loading ...

— 17 —

STEP 11

Venting

• Depending on exterior ventilation chosen (see page 10), either exit the ducting through the ceiling or wall.

• Alwaysuserigidtypemetal/aluminumducttube(followthebuildingcodesinyourarea)tomaximizeairow.Makesure

thatthebackdraftapscanopen,toallowmaximumairow.Connecttheducttubetothevent/damperandsecurely

seal with certied aluminum or foil tape so that it is air tight. Please check the building codes in your city to learn which

tape product is recommended.

• Connect ductwork to damper. Use Duct Tape to ensure joint is sealed and air tight.

IMPORTANT:

• Observeallgoverningcodesandordinances.

• It is the customer’s responsibility to contact a qualified electrical installer.

• Ifcodespermitandaseparategroundwireisused,itisrecommendedthata

qualified electrician determine that the ground path is adequate. A 120-Volt, 60

Hz,AC-only,fusedelectricalsupplyisrequiredonaseparate15-ampcircuit,

fused on both sides of the line.

• DONOTgroundtoagaspipe.

• Checkwithaqualifiedelectricianifyouarenotsurethattherangehoodisproperlygrounded.

• DONOThaveafuseintheneutralorgroundcircuit.

IMPORTANT: Save this Installation Guide for electrical inspector’s use.

• Therangehoodmustbeconnectedwithcopperwireonly.

• The range hood should be connected directly to the fused disconnect (or circuit breaker) box through flexible

armored or non-metallic sheathed copper cable. UL/CSA listed strain relief must be provided at each end of the

power supply cable.

Installation

Figure 24 Figure 25

Figure 26 Figure 27

Loading ...

Ancona AN1258 30 Inch Stainless Steel Ducted Standard Hood Under Cabinet Hood