Loading ...
Loading ...
Loading ...
9 ENGLISH
Removing screw strip
To remove the screw strip, pull it upwards out of the feeder box.
Fig.13
The screw strip can be pulled downwards out of the feeder
box while pressing the reverse button on the feeder box.
1
2
Fig.14
► 1. Reverse button 2. Feeder box
Installing hook
CAUTION:
When installing the hook, always
secure it with the screw rmly. If not, the hook may
come o from the tool and result in the personal injury.
1
1
2
3
2
3
Fig.15
► 1. Groove 2. Hook 3. Screw
The hook is convenient for temporarily hanging the tool. This can
be installed on either side of the tool. To install the hook, insert it
into a groove in the tool housing on either side and then secure it
with a screw. To remove, loosen the screw and then take it out.
OPERATION
Driving operation
NOTICE: Always check the driver bit carefully
for wear before driving operations. Replace a worn
driver bit or poor fastening may result.
NOTICE: Always hold the tool squarely against
the driving surface. Holding it at an angle may dam-
age the screw heads and cause wear on the driver
bit. This may also lead to poor fastening.
NOTICE: Always keep the tool rmly against the
driving surface until the driving is over. Failure to
do so may cause insucient fastening of screws.
NOTICE: Be careful not to drive a screw onto
another screw already fastened.
NOTICE: Do not operate the tool without screws.
It will damage the driving surface.
NOTICE: If the feeder box does not work
smoothly when driving screws, spray car wax
(spray type) on the sliding surfaces. Never lubri-
cate it.
Switch on the tool by pulling the switch trigger. Hold the
tool squarely and rmly up against the driving surface. A
screw will be automatically carried to the driving posi-
tion and fastened.
Fig.16
Loading ...
Loading ...
Loading ...