Loading ...
Loading ...
Loading ...
www.husqvarna.com
Original instructions
1143110-26
2023-06-15
- Contents
- Introduction
- Safety
- Assembly
- Introduction
- To attach the throttle handle
- To assemble the handlebar
- To set the handlebar in transport position
- To assemble the cutting equipment
- To attach and remove the guard extension
- To attach the grass blade and the grass blade guard/combination guard
- To attach the saw blade guard on 545FX AT and 545FXT AT
- To attach the saw blade guard
- To attach the saw blade
- To attach the trimmer guard or combination guard for trimmer head and plastic blades
- To attach a trimmer head or plastic blade
- To adjust the Balance XT harness
- Operation
- Introduction
- Husqvarna Connect
- To start to use Husqvarna Connect
- Before you operate the product
- Fuel
- Work position
- Correct balance of the product
- To start the engine
- To stop the engine
- Heated handles
- Blade thrust
- General work instructions
- Forestry clearing with a saw blade
- Brush cutting with a saw blade
- Grass clearing with a grass blade
- Grass trimming with a trimmer head
- Maintenance
- Introduction
- Maintenance schedule
- To clean the muffler
- To clean the cooling system and starter pawls
- Air filter
- To lubricate the bevel gear
- Drive shaft
- To attach and remove the locknut
- To examine the spark plug
- To adjust the engine
- To sharpen the grass knife and grass blade
- To sharpen the saw blade
- To adjust the product for cold environments
- To lubricate the wire
- Troubleshooting
- Transportation, storage and disposal
- Technical data
- Accessories
- Registered trademarks
- Declaration of Conformity