Loading ...
Loading ...
Loading ...
3. Remove the grease plug.
4. Look into the grease plug hole and turn the drive
shaft. The grease level (A) must be in level with the
top of the gear cogs (B).
A B
5. If the grease level is too low fill the bevel gear with
Husqvarna bevel gear grease. Fill slowly and turn
the drive shaft as you apply the bevel gear grease,
stop at the correct level (B).
CAUTION:
An incorrect quantity of
grease can cause damage to the bevel
gear.
6. Install the grease plug.
Drive shaft
Lubricate the drive shaft at an interval of 3 months. Let
a service agent help you if you are not sure about the
procedure.
To attach and remove the locknut
WARNING:
Stop the engine, use
protective gloves and be careful around the
sharp edges of the cutting attachment.
Use the locknut to attach some types of cutting
attachments. The locknut has a left thread.
• Use a socket wrench with a shaft that is sufficiently
long to let you keep your hand behind the cutting
attachment guard. The arrow in the illustration shows
the area where you can safely operate the socket
wrench.
• To attach, tighten the locknut in the opposite
direction to how the cutting attachment rotates.
• To remove the locknut, turn it in the same direction
as how the cutting attachment rotates.
• Keep count when you remove and attach the
locknut. Replace the locknut after approximately 10
times.
Note:
Make sure that you can not turn the locknut by
hand. Replace the locknut if the nylon lining does not
have a resistance of a minimum of 1.5 Nm.
To examine the spark plug
CAUTION:
Always use the
recommended spark plug type. Incorrect
spark plug type can cause damage to the
product.
• Examine the spark plug if the engine is low on
power, is not easy to start or does not operate
correctly at idle speed.
24
171 - 011 - 05.06.2023
Loading ...
Loading ...
Loading ...