Loading ...
Loading ...
Loading ...
8
DRY VACUUM OPERATION
DRY VACUUMING
1. Verify that the power cord is disconnected from the outlet (Fig. 1).
2. In order to prepare your vacuum for dry vacuuming, verify that the cartridge lter completely
covers the lter cage. Your Wet/Dry Vacuum comes with the cartridge lter pre-installed. For
installation instructions, see page 14.
3. Place the power head back on the collection tank, and secure it in place using the latches (Fig. 2).
OPERATING INSTRUCTIONS: DRY VACUUMING
4. Insert the locking end of the hose into the vacuum port and turn to lock into place (Fig. 3).
5. Choose the desired accessory and insert onto the end of the hose or extension wand (Fig. 4).
6. Plug the power cord into the outlet (Fig. 5).
7. Turn the motor on by pressing the on/off switch to the ‘I’ (ON) position and begin vacuuming (Fig. 6).
8. Once you have completed vacuuming, press the on/off switch to the ‘O’ (OFF) position and
unplug the power cord from the outlet.
O = OFF I = ON
DO NOT USE THE CARTRIDGE FILTER FOR LIQUID VACUUMING.
DO NOT USE THE COLLECTION BAG FOR LIQUID VACUUMING.
4
6
3
1 5
2
WARNING
: BE SURE TO READ, UNDERSTAND, AND APPLY INFORMATION
ENTITLED ‘IMPORTANT SAFETY INSTRUCTIONS’. DO NOT VACUUM IN AREAS
WITH FLAMMABLE GASES, VAPORS, OR EXPLOSIVE DUSTS IN THE AIR.
FLAMMABLE GASES OR VAPORS INCLUDE BUT ARE NOT LIMITED TO: LIGHTER
FLUID, SOLVENT TYPE CLEANERS, OIL-BASED PAINTS, GASOLINE, ALCOHOL,
OR AEROSOL SPRAYS. EXPLOSIVE DUSTS INCLUDE BUT ARE NOT LIMITED TO:
COAL, MAGNESIUM, GRAIN, OR GUN POWDER. TO REDUCE THE RISK OF HEALTH
HAZARDS FROM VAPORS OR DUST, DO NOT VACUUM TOXIC MATERIALS.
WARNING
: DO NOT PLUG POWER CORD INTO POWER OUTLET. MAKE SURE
PLUG IS DISCONNECTED BEFORE CHANGING THE FILTERS.
NOTICE
: Do not vacuum drywall dust or replace soot or ash with standard Wet/
Dry lter. This is a very ne dust which will not be captured by the lter and may
cause damage to motor. When vacuuming ne dust use a ne dust lter (sold
separately).
Loading ...
Loading ...
Loading ...