Loading ...
Loading ...
Loading ...
7
GENERAL ASSEMBLY INSTRUCTIONS
UNPACKING YOUR WET/DRY VACUUM & GENERAL ASSEMBLY
1. Verify that the power cord is disconnected from the outlet (Fig. 1).
2. Undo the latches (Fig. 2).
3. Lift the power head off the collection tank (Fig. 3).
4. Remove the contents from inside the collection tank; make sure you have all contents as listed
on carton content list on page 6 (Fig. 4).
5. Turn the collection tank upside down and insert the four caster feet into the slots on the
collection tank and tighten with supplied screws. Verify that the casters are mounted correctly.
Do not over-tighten screws (Fig. 5).
6. Your vacuum comes ready for dry vacuum cleaning. If the cartridge lter is not installed, refer
to page 14 for installation instructions (Fig. 6).
7. For wet vacuum cleaning, remove the cartridge lter, install the supplied foam wet lter (Fig. 7).
See page 15 for the foam wet lter installation instructions.
8. Place the power head back on the collection tank, aligning the top section with the latches, and
snap into place (Fig. 8 & 9).
9. Insert the locking end of the hose into the vacuum port of the collection tank and turn to lock
into place (Fig. 10).
10. Choose the desired accessory and insert onto the end of the hose or extension wand (Fig. 11).
POLARIZED PLUG
To reduce the risk of electrical shock, this appliance has a polarized plug (one blade wider than the
other). This plug will t in a polarized outlet only one way. If the plug does not t fully in the outlet,
reverse the plug. If it still does not t, contact a qualied electrician to install the proper outlet.
Do not change the plug in any way. Double insulation eliminates the need for the three wire
grounded power cord and grounded power supply system.
A Philips head screw driver is required.
1
4
5
2
11
3
10
7
6
9
8
WARNING
: DO NOT PLUG POWER CORD INTO POWER OUTLET. MAKE SURE
PLUG IS DISCONNECTED BEFORE ASSEMBLING THE WET/DRY VACUUM.
TO REDUCE THE RISK OF ELECTRIC SHOCK, DO NOT EXPOSE TO RAIN.
Loading ...
Loading ...
Loading ...