Loading ...
Loading ...
Loading ...
-19-
Step 1
Assemble U shaped tube
Place the table saw on a clean level surface
with the table top facing the ground, as shown
in Fig. A. Place the stand assembly on top of
the tool so that the Material support touches
the ground and is on the left side of the table
saw (from the front). Use 4 3.5 inch carriage
bolts and lock nuts to secure the tool to the
stand (no washers required. The nuts should
be on the bottom side of the stand frame. Insert
the two ends of the handle bar (Stand Item 4)
into the matching ends of the stand main tubes
attached to the bottom of the table saw as
shown in Fig. A. Note that the curves of the
handle bar point up. For each end, insert one 2
inch carriage bolt from the bottom all the way
through the tube. Place a washer over the
threads and then screw on the nut. Use a 1/2
inch or adjustable wrench to fully tighten. See
Fig. A.
Handle Bar
Handle Bar
Carriage Bolt,
Washer & Nut
Tool Stand Bolts
Assembly
Step 2
Assemble H shaped tube to stand tube with
feet
Place the H shaped tubes (Stand Item 5) in the
position shown in Fig. B so that the holes at the
bend in the H shaped tube line up with the
holes in the outside stand tubes (tubes with the
feet). For each side, Insert one 3.5 inch car-
riage bolt through the outside of stand tubes
(tubes with the feet). Place a plastic spacer be-
tween the outside bar and the H shaped tube
and push the bolt through the spacer and the H
shaped tube. Place one washer over the
threads and then screw on the nut. Use a 1/2
inch or adjustable wrench to tighten. The nut
should be tight enough so that there are no
gaps, but not so tight as to prevent the bars
from rotating. See Fig. B.
Handle Bar
Handle Bar
Carriage Bolt,
Washer & Nut
H Shaped Tube
Outside Stand Tube
FIG. BFIG. A
Loading ...
Loading ...
Loading ...