Loading ...
Loading ...
Loading ...
5. Health and Safety Information
• DO NOT exceed the maximum stated air pressure of
this compressor or any connected tools.
− The pressure of the air supply MUST NOT exceed
more than 10% of the rated pressure of any
connected tool.
• NEVER carry the compressor or any connected tool
by the air line.
• DO NOT use this tool in temperatures that do not fall
within 0–40°C.
• DO NOT use this product to supply air tools that
require greater air ow than this compressor can
provide.
• NEVER strike or pierce the compressor tank or expose
it to ames sources or sources of heat.
• DO NOT use this product if you suspect that the
integrity of the compressor tank has been
compromised.
• NEVER weld anything to or drill holes in the
compressor tank.
• Drain the compressor tank of condensation before
and after EVERY use and before storing the product.
• Have the safety valve replaced every 12 months by an
authorised service agent.
WARNING! DO NOT use this product if the
safety valve or gauges are damaged in any way.
The tank pressure must be monitorable and able
to self-vent in the event of over-pressurisation.
WARNING! This product may become hot during
use. DO NOT touch the motor housing or
compressor tank during use. Allow the product
to cool before adjusting, moving or maintaining
the product.
WARNING! ALWAYS depressurise the tank after
use; DO NOT store the compressor with a
pressurised tank.
5.3 Additional Safety Instructions for
Rechargeable Batteries
Important: Use ONLY Draper Tools D20 range 4.0Ah
(Stock No. 55898) and 5.0Ah (Stock No. 55907) battery
packs and chargers with this product (not supplied).
Read all instructions supplied with the batteries and
charger before use.
WARNING! DO NOT use or charge the battery if
leakage is evident.
• Recharge batteries ONLY using the charger specied.
• DO NOT open, crush or burn the battery as this may
release potentially harmful chemicals.
• DO NOT expose the battery to temperatures greater
than 50°C.
• Charge the battery in a dry and well-ventilated
environment in ambient temperatures between 5 and
40°C, ensuring that the ventilation slots on the
charger casing are not obstructed.
• DO NOT attempt to charge batteries that exhibit a
temperature that is not between 5 and 30°C.
− Allow batteries that are too hot or too cold to
normalise before charging.
• DO NOT short-circuit the battery by connecting the
positive and negative terminals while it is outside of
the product.
− Keep the battery away from metallic objects that
may inadvertently cause a connection between
the terminals.
• DO NOT expose the battery pack to rain or other wet
conditions or immerse it in liquid.
• ALWAYS remove the battery before storing the
product for extended periods.
• ALWAYS remove the battery from the tool before
recycling and dispose of it in accordance with local
regulations.
• If a re occurs, use a CO
2
or dry chemical
extinguisher.
WARNING! The electrolyte in the battery pack is
corrosive. Avoid contact with skin.
If contact occurs, ush the area with clean water and pat
it dry. Seek medical attention at the earliest opportunity
and inform the responder that the contaminant is a
“high-alkaline corrosive liquid”. If contact with the eyes
occurs, ush immediately with plenty of water ONLY and
seek medical advice at the earliest opportunity.
5.4 Residual Risk
The safety instructions in this manual cannot account for
all possible conditions and situations that may occur.
Exercise common sense and caution when using this
product and protect against any additional conceivable
risks.
– 8 –
Loading ...
Loading ...
Loading ...