Loading ...
Loading ...
Loading ...
8. Maintenance and Troubleshooting
EN
8.3 Storing the Compressor
• ALWAYS, before storing the product:
− Remove the battery.
− Turn the output pressure regulator (9) fully
anticlockwise.
− Depressurise and drain the compressor tank; see
8.2 Draining Moisture from the Compressor Tank.
− Detach the air line or tool and hang the open end
vertically downward to drain any residual
moisture.
− Open the drain valve (4).
− Depressurise any other air tools before storing
them.
• Store the product in a cool, clean and dry
environment, out of direct sunlight and out of the
reach of children.
• DO NOT store this product in environments exceeding
40°C.
• ALWAYS store the product in its upright position.
– 15 –
Problem Possible Cause Remedy
The compressor does not start up. The battery is missing or
discharged.
Check that at least one battery with
sucient charge is installed.
The compressor is switched o. Move the on/o switch to the on
position.
The tank is at maximum pressure. The tank will automatically
repressurise when pressure drops to
approx. 5.4bar.
The ambient temperature is too low. Move the compressor to an
environment with an ambient
temperature of 5°C or greater.
The thermal overload safety feature
has been activated.
Switch o the compressor and allow
it to cool for at 30 minutes before
reuse.
The tank or output pressures are
abnormally low.
Connections are loose or a seal is
damaged.
Inspect all connections for loose
ttings or damaged parts. Have any
damaged parts replaced
immediately.
The output pressure regulator is set
too low.
Turn the output pressure regulator
clockwise to increase the output
pressure.
The safety valve is faulty. Cease operations immediately and
contact Draper Tools for support.
DO NOT adjust the safety valve.
8.4 Troubleshooting
Loading ...
Loading ...
Loading ...