Loading ...
Loading ...
Loading ...
LY
INSTALL MOWER AND DRIVE BELT (See
Figs. 4 and 6)
Be sure tractor is on level surface and mower suspension
arms are raised with attachment lift control,,Engage park-
ing brake.
• Cut and remove ties securing anti-swaybar and belts.
Swing anti-sway bar to left side of mower deck.
o Slide mower under tractorwith dischargeguardto right
side of tractor_
IMPORTANT: CHECK BELT FOR PROPER ROUTING IN
ALL MOWER PULLEY GROOVES. INSTALL BELT INTO
ELECTRZC CLUTCH PULLEY GROOVE.,
= Install one front link in top hole of the R,H. front mower
bracket and R.H front suspension bracket° Retain with
two single loop retainer springs as shown.
° Install second front link in LH, front suspension bracket
only and retain with single loop retainer spring as
shown.
= Turn height adjustment knob counterclockwise until it
stops.
° Lower mower linkage with attachment lift control
• Place the Loll, suspension arm on inward pointing deck
dPin_If necessary, rock and raise front of mower to align
eck pin with the hole in suspension arm,
° Slide left side of mower back and install the unattached
front link in top hole of the LoHofront mower bracket,
Retain with single loop retainer spring as shown,
• Place the R°Ho suspension arm on inward pointing
deck pin, If necessary, rock and raise front of mower
to align deck pin with the hole in suspension arm,
° Connect anti-sway bar to chassis bracket under left
footrest and retain with double loop retainer spring.
° Retain both suspension arms to deck pins with double
loop retainer springs,
• Turn height adjustment knob clockwise to remove
slack from mower suspension_
o Raise mower to highest position,,
° Assemble gauge wheels (See "TO ADJUST GAUGE
WHEELS in the Operation section of this manual),
CHECK MOWER LEVELNESS
For best cutting results, mower shouldbe propedy leveled.
See "TO LEVEL MOWER HOUSING in the Service and
Adjustments section of this manual
CHECK FOR PROPER POSITION OF ALL
BELTS
See the figures that are shown for replacing motion, mower
drive, and mower blade drive belts in the Service and
Adjustments section of this manual Verify that the belts
are routed correctly,
ELECTRIC
CLUTCH
PULLEY,
FRONT
SUSPENSION
BRACKETS
DOUBLE LOOP
RETAINER SPRING
CHASSIS (Inward pointing
BRACKET deck pins)
SUSPENSION
ARMS
FRONT
MOWER
BRACKET
FRONT
LINK
SHOULDER
BOLT
GAUGE
WHEEL
3_ WASHER
3/8-16
CENTER
LOCKNUT
DOUBLE LOOP
RETAINER
SPRING
ANTI-SWAY
BAR
IDLER
PULLEY
FIG. 4
SINGLE
LOOP
RETAINER
SPRINGS
DISCHARGE GUARD
9
Loading ...
Loading ...
Loading ...