Loading ...
Loading ...
Loading ...
Strength Training Collection 11 10 GluteBlast User Manual Lifepro
RAISE THE COLUMN
FOR THE SUPPORT CUSHION
1. Gather the M8×60mm bolt (I), one M8 nut (K), two hex keys (L), and
wrench (M).
2. Locate the column for the support cushion. It is folded down on the
surface of the main frame near the padded rollers. See Figure 2.
3. Pull the column out and the rotate it up 90-degrees. See Figure 2.
NOTE: If the bottom pre-installed bolt is too tight to pull out and rotate
the column, use the large hex key to loosen it.
4. Push the column straight down so that the bolt holes in the column and
the bracket line up. See Figure 2.
5. Insert the M8×60mm bolt (I) into the top bolt hole and place the
nut (K) onto the end of the bolt.
6. Use the small hex key and the wrench to fully tighten the nut and bolt.
7. If you loosened the bottom bolt, use the large hex key to re-tighten it.
ROTATE THE SUPPORT
CUSHION POST
1. Gather the support cushion (C), M8×50mm bolt (J), M8 nut (K), small
hex key (L), and wrench (M).
2. Place the support cushion flat on the ground. See Figure 3.
3. Rotate the post down 90-degrees. See Figure 3.
4. Insert the M8×50mm bolt (J) into the bottom bolt hole and place the
nut (K) onto the end of the bolt.
5. Use the small hex key and the wrench to fully tighten the nut and bolt.
See Figure 3.
2 3
Figure 3Figure 2
Rotate
Post Up
Rotate Post
Down
Pull Column
Out
Push Column
Down to Align
Bolt Holes
I
J
K
K
Loading ...
Loading ...
Loading ...