Loading ...
Loading ...
Loading ...
Page 24
Troubleshooting
Problem Possible cause Possible solution
The programme
does not start.
Appliance door is open.
Delay start is set.
Power plug is not connected
in the power socket.
Fuse in the house circuit is
damaged.
Rinse aid dispenser is empty Refill Rinse aid until full.
Replace the fuse.
Connect the power plug.
Refer to displayed time.
Close the appliance door.
Rinse Aid Indicator
is light.
Acoustic alarm,
display shows
ALARMCODE A10
The appliance does
not fill with water.
Water tap is closed.
Open the water tap.
Note: Whenever Error ‘A10’ is solved switch off the appliance
and restart the programm.
Water inlet hose has a kink or
a bend.
Make sure that the position of the hose is correct.
In case of aqua-stop system:
water protection is triggered;
the marker (C) is red.
The hose must be replaced.
Filter in the water inlet hose
is clogged.
Clean the filter at the inlet hose connections at tap and the
rear of the appliance.
Water inlet is clogged.
Water pressure is too low.
Check water flow from tap.
Contact your local water authority.
Acoustic alarm,
display shows
ALARMCODE F30
Leak: The drain
pump runs
permanently.
Anti-flood device is on:
There are water leakages in
the appliance.
The water inlet valve is open
and blocked.
The drainage is blocked.
Close the water tap.
Disconnect appliance from power supply.
Contact Service.
The dishes are not
clean.
Filters are clogged.
Filters are not correctly
assembled and installed.
Clean the filters.
Make sure that the filters are correctly assembled and
installed.
Remove remaining food remnants with a thin pointed object.Spray arms are clogged.
Programme was not applicable
for the type of load and food
remnants.
Make sure that the programme is applicable for the type of
load and food remnants.
Incorrect position of the items
in the baskets. Water could not
wash all items.
Make sure that the position of the items in the baskets is
correct and that the water can easily wash all items.
Spray arms could not turn freely.
Make sure that the position of the items in the baskets is correct
and does not cause the blockage of the spray arms.
No detergent or insufficient
quantity of detergent in the
detergent dispenser.
Make sure that you add the correct quantity detergent in the
dispenser before you start a programme.
The wash cycle was interrupted
by a long break.
Do not open the door or cut power supply during the wash
cycle.
Loading ...
Loading ...
Loading ...