Loading ...
Loading ...
Loading ...
GPW3200 GAS PRESSURE WASHER
22
tank, carburetor, and hose. Screw the carburetor
drain hex screw back once the fuel has been
completely drained.
2. Add fuel stabilizer
• If you do not wish to drain the fuel tank (11), add a
fuel stabilizer into the fuel tank. Run the engine at
least five minutes after adding the stabilizer to
distribute it inside the fuel system.
3. Drain oil
• Drain the oil (→Draining Engine Oil).
• Remove the spark plug.
• Pour one tablespoon (14 ml) of
10W-30
oil through
the spark plug hole.
• Make sure the engine
I/O
switch (12) is set to
O
position. Slowly pull the starter cord handle (6) until
you feel tension, which indicates the piston is on its
compression stroke and leave it in this position.
• Replace the spark plug.
7.6 Winterizing Procedure
• Pressure washer might be damaged if subjected to
freezing temperatures. This type of damage is not
covered by the limited warranty. To avoid possible
damages, use a small amount of antifreeze.
• Place the pressure washer on its side, with the
water inlet (17) facing upwards, and pour 1/4 cup (60
ml) of antifreeze into the water inlet.
• Make sure the engine
I/O
switch is set to
O
position and pull the starter cord handle several times
to distribute the antifreeze inside the pump system.
• When taking the pressure washer out of storage,
run water through the system until it runs clear.
IMPORTANT
• If the pressure washer is to be stored with
gasoline in the fuel tank and carburetor, it is
important to reduce the hazard of gasoline vapour
ignition.
• Select a well-ventilated storage area away from
any appliance that operates with a flame, such as a
furnace, water heater, or clothes dryer. Also avoid
any area with a spark-producing electric motor, or
where power tools are operated.
• If possible, avoid storage areas with high
humidity, because that promotes rust and
corrosion.
• Place the pressure washer on a level surface.
Tilting can cause fuel or oil leakage.
• Do not use plastic sheets as a dust cover. A
nonporous cover will trap moisture around the
pressure washer, promoting rust and corrosion.
Loading ...
Loading ...
Loading ...