Loading ...
Loading ...
Loading ...
GPW3200 GAS PRESSURE WASHER
20
The engine oil should be replaced after the first 20
hours of operation, or after the first month of use.
After that, it should be replaced every 100 hours or
every six months.
To drain the engine oil:
1. Loosen the oil tank dipstick (20).
2. Place an oil container underneath the opening on
the mainframe.
3. Remove the hex screw and drain the oil.
4. Once the oil has been completely drained,
retighten the hex screw and oil tank dipstick.
Recommended Engine Oil
Add oil as described in chapter → Adding/Checking
Oil.
Checking Air Filter
Inspecting, Replacing or Cleaning the
Spark Plug
The spark plug should be checked after every 100
hours of operation or every six months.
To replace or clean the spark plug:
1. Disconnect the spark plug wire by pulling it off the
spark plug.
2. Using provided spark plug wrench (M), remove
the spark plug by turning it counter-clockwise. If
there is a carbon sediment build-up, remove it. If
there is too much carbon sediment, replace the
spark plug.
IMPORTANT
Used oil is a hazardous waste product and must be
disposed of properly. Do not discard with
household waste. Check with your local authorities,
service centre.
IMPORTANT
Clean air filter (3) element after every 50 hours of
use (every 10 hours under dusty conditions). Wash
in high flashpoint solvent, squeeze dry, dip in clean
engine oil, and squeeze out excess oil.
Loading ...
Loading ...
Loading ...