Loading ...
Loading ...
Loading ...
Page 13
LIQUID VACUUM OPERATION
2. Verify that the switch is in the ‘O’ OFF
position before plugging the power cord into
the outlet (Fig. 4).
Fig. 4
3. Turn the motor on by turning the switch to
the ‘I’ ON position (Fig. 5).
Fig. 5
4. After use, empty the collection tank by
unscrewing the drain cap. Drain liquids into
a suitable receptacle or drain. Remember
to refit the drain cap to the collection tank
after draining (Fig. 6).
Fig. 6
IMPORTANT!
When vacuuming large
quantities of liquids, do not immerse the nozzle
completely in the liquid; leave a gap at the tip
of the nozzle opening to allow air inflow. The
machine is fitted with a f loat valve that stops the
suction action when the collection tank reaches
its maximum capacity. You will notice an
increase in motor speed. When this happens,
turn off the machine, disconnect from power
supply, and drain the liquid into a suitable
receptacle or drain. To continue vacuuming,
refit the collection tank with the drain cap.
After wet vacuuming, turn the machine off and
remove plug from power supply. Empty the
collection tank, clean and dry the inside and
outside before storage.
REMEMBER!
The foam filter must be removed
after wet vacuuming, and the HEPA filter must
be reinstalled before dry vacuuming again.
Loading ...
Loading ...
Loading ...