Loading ...
Loading ...
Loading ...
Page 12
LIQUID VACUUMING
WARNING:
BE SURE TO READ,
UNDERSTAND, AND APPLY, INFORMATION
ENTITLED ‘SAFETY INSTRUCTIONS &
WARNINGS’. DO NOT VACUUM IN AREAS
WITH FLAMMABLE GASES, VAPORS,
OR EXPLOSIVE DUSTS IN THE AIR.
FLAMMABLE GASES OR VAPORS INCLUDE
BUT ARE NOT LIMITED TO: LIGHTER
FLUID, SOLVENT TYPE CLEANERS, OIL
BASED PAINTS, GASOLINE, ALCOHOL, OR
AEROSOL SPRAYS. EXPLOSIVE DUSTS
INCLUDE BUT ARE NOT LIMITED TO: COAL,
MAGNESIUM, GRAIN, OR GUN POWDER.
TO REDUCE THE RISK OF HEALTH
HAZARDS FROM VAPORS OR DUST, DO
NOT VACUUM TOXIC MATERIALS.
WARNING:
DO NOT PLUG POWER
CORD INTO POWER OUTLET; MAKE
SURE PLUG IS DISCONNECTED BEFORE
ASSEMBLING THE WET/DRY VAC.
1. Verify that the power cord is disconnected
from the outlet (Fig. 1). Make sure that the
collection tank is clean and free from dust
and dirt.
Fig. 1
2. Remove all filters and dispose of properly.
3. Rinse the inside of the collection tank to
remove any loose debris and dispose of
liquid in suitable container.
4. Carefully install the foam wet filter over the
filter cage and place the power head back
on the collection tank (Fig. 2). See filter
installation instructions on page 17.
Fig. 2
DO NOT USE THE HEPA FILTER FOR
LIQUID VACUUMING.
WARNING:
IF FILTERS ARE
CONTAMINATED OR HAVE BEEN USED,
THEY MUST BE DISPOSED OF PROPERLY,
PRIOR TO PERFORMING WET VACUUMING
OPERATIONS.
OPERATING INSTRUCTIONS: WET
VACUUMING
1. Fit the desired nozzle to the vacuum hose
(Fig. 3).
Fig. 3
LIQUID VACUUM OPERATION
Loading ...
Loading ...
Loading ...