Loading ...
Loading ...
Loading ...
20
|
CARE & USE/INSTALLATION
O
nce the wireless wall switch has been successfully
programmed, repeat the process with the touch screen
remote control. Once again, press the LEARN button on
the receiver. Release the LEARN button. You will now hear
a single beep. NOTE: If programming more than one unit,
press and release the LEARN button on all units before
turning the remote ON. Now push the lower center MODE
SET button on the transmitter until the word ‘ON’ is
displayed in the upper left hand corner. Once the code is
accepted, you will hear four beeps in rapid succession.
You should also hear the pilot sparking rapidly. This
confirms that the signal has been received, and your
programming was successful. Press the mode button until
‘OFF’ is displayed at the top right side of the screen. Re-
confirm proper functioning by turning the transmitter back
to ‘ON’ and listening for rapid sparking of the pilot. Once
confirmed, press the mode set button until ‘OFF’ appears,
to shut the system off.
Replace the plastic cap over the LEARN BUTTON access
hole. Replace the louvered end plate over the open end
of the heater and tighten the two screws. Take care not to
pinch wires when re-attaching the end plate.
Refer to the section ‘TOUCH SCREEN REMOTE CONTROL
OPERATION’ Page 21, to learn more about the remote
operations that are possible with your Lynx Heater.
BASIC OPERATION OF YOUR HEATER
Your new Lynx Eave Mount Patio Heater has been
designed with cutting edge technology and easily
operates with either the manual ON-OFF-HI-LOW wall
switch or with the use of a touch screen remote control.
Please study the section of this manual entitled ‘Remote
Control Operation’ to allow a full understanding of the
heater’s capabilities.
MANUAL OPERATION
1.TURN THE GAS ON. If this is a Natural Gas (NG)
installation, turn the manual shut-off valve lever ¼ turn so
that the lever is parallel and in-line with the gas line. If this
is a Liquid Propane (LP) installation, open the gas cylinder
valve by a minimum of one full turn, and if connected to a
quick disconnect hose, turn the in-line valve lever by ¼
turn so that the lever is parallel and in-line with the gas
line.
2.At the wall switch, push the ‘ON’ button, and listen for the
pilot to spark rapidly. After the pilot sparks, you will hear
the small pilot flame ignite. Shortly after that, you will hear
the main burner of the heater ignite. When using the wall
switch, the heater will light on ‘HIGH’ regardless of the
previous setting when it was turned off. Allow the heater
to warm up for a few seconds, and then press the ‘LO’
button to adjust the heat downward. Each press of the
button will lower or raise the heat level by one increment.
If you hold the ‘HI’ button continuously, the heat level will
advance more rapidly. Likewise, when you press the ‘LO’
button, the heat will become lower by one increment, and
by pressing the ‘LO’ button continuously, the heat level
will decrease more rapidly. Push the “OFF’ button when
finished using the heater.
PROGRAMMING YOUR REMOTE...continued
When the heater is being lit for the first time after
installation, or after hooking up a gas line for the first
time, the gas lines will need to purge themselves
of the air to fill with gas. Depend-ing on the length of
gas lines, this may take a few minutes or more. The
spark ignition system is designed to spark for 1
minute, and then time out. This is part of the ignition
safety system.
IMPORTANT NOTE
If this occurs, simply turn the wall switch to OFF, and then turn back to ON. The spark will return to its normal function.
Repeat this operation until the pilot lights. Once the pilot lights, the heater will light within seconds.
Loading ...
Loading ...
Loading ...