Loading ...
Loading ...
Loading ...
CARE & USE/INSTALLATION
|
11
A typical gas supply line might consist of ½” piping
beginning at the gas supply source. This line will be routed,
within the shortest possible distance, up to the vicinity of
the heater location (30 Ft. MAX). This line, as previously
mentioned, willhave a ½” lever- handled gas shut-off
valve installed in-line, and within 6-feet of the termination
point. After final heater positioning and mounting angle is
created, the pipe line is then routed directly to the ½” NPT
(female) coupling at the end of the heater. As an alternate
to this installation, after the gas line has been routed to
the vicinity of the heater, and after final positioning and
pivot angle has been determined, a short gas flex line can
be installed from the end of the hard pipe to the ½” NPT
(female) coupling on the heater. This flex line should be
1/2” I.D. (5/8” O.D.), Stainless Steel, with ½”MIP fittings at
both ends. A ½” FIP coupling will then be used to connect
the flex line to the hard pipe. The use of this flex line allows
for additional angle (pivot) adjustment of the heater after
installation has been complete.
GAS LINE PURGING
You should purge the gas line of air before attempting to
light the heater.
• Slowly turn on the main gas supply.
• With the gas on, loosen one connection near the
heater until you either ‘hear’ gas or ‘smell gas’. Tighten
connection immediately. This should purge the remaining
air from the lines.
GAS CONNECTION INFORMATION ...continued
ELECTRICAL CONNECTION INFORMATION
Touch Screen Remote Control- 6.0 V (four 1.5 V AAA batteries) supplied
Radio Frequency (Remote Control and Receiver) – 303.8 MHz
Heater Battery Supply- 6.0 V (four 1.5V AA batteries) supplied
Receiver Module – powered by battery supply and/or AC Adaptor
Valve and Pilot- rated @ 3 V DC
AC/DC Adaptor (Transformer)-Input AC 100-240V-0.3A, 60/50Hz Output 7.5V ---1000mA 10W Max, cord length -24 in
NOTE: If the AC/DC Transformer (Lynx P/N 33937) is NOT being used, then there is no preliminary electrical
preparation required. If the transformer IS going to be used, then there must be electrical considerations. A GFI
protected, 110 V grounded electrical power outlet must be placed within 24 inches of the end, DC jack receptacle on
the heater.
ELECTRICAL SUPPLY SPECIFICATIONS AND CONNECTIONS
Loading ...
Loading ...
Loading ...