Loading ...
Loading ...
Loading ...
16. Motion Drive Belt Removal
The tractordrive belt may be replaced withouttools_Parkthe
tractoron level area,,Engageparking brake. NOTE: A BELT
INSTALLATION DECAL IS UNDER LEFT FOOTREST
ao Remove mower (See page 21).
b_ Remove two retainer springs from belt guide
bracket below transaxle pulley Remove bracket
(Fig,,22),
c. Swing belt guides away from belt, toward rear of
tractor (Fig, 22).
d. Roll belt over top of transaxle pulley°
eo Roll belt over engine pulley and off idler (Fig 23),
fo Release parking brake., Pull belt as far as possible
over top of clutch pulley
g, Reset parking brake. Pull belt over top of clutch pul-
ley (Fig. 23).
h.. Pull belt out through shift gate to remove from trac-
tor (Fig., 24),
io Install belt by reversing above procedure,
REPLACE BELTONLY WITH THE BELT !
LISTED IN THE REPAIR PARTS SEC-
TION OF THIS MANUAL.
17. Fuse Replacement
Replace with 30 amp automotive-type plug-in fuse. The
fuse holder is located under the dash,
REPAaR AND ADJUSTMENT
BELT
GUIDE
TRANSAXLE
r l
RETAINER
SPRING
CLUTCH
PULLEY_
BELT GUIDE
BRACKET
ENGINE
PULLEY
RETAINER
SPRING
F,_GURE22
BELT
_N
DECAL
L,H, SIDE
BELT GUIDE
REAR __ _ ,__-
VIEWED FROM BOTTOM OF TRACTOR
F/GURE 23
BELT _..
SHIFT GATE
19 FIGURE24
Loading ...
Loading ...
Loading ...