Loading ...
Loading ...
Loading ...
1514
Assembly, Operation & Maintenance InstructionsAssembly, Operation & Maintenance Instructions
STEP 01
/ The hood and barbeque chassis assembly is transported screwed to the stand top by
four M6x20mm screws and four Ø6mm spring washers (two at the front and two at the
rear). Before attempting to build the stand, the stand top should be removed.
Angle the assembly slightly to the back and remove both M6x20mm screws, then do the
same at the front, supporting the parts so they don’t drop. Keep all of the fasteners for
later use. Removable stickers at the front and rear will mark the positions of these screws.
Remove the hood and barbeque chassis assembly from the stand top and place on the
ground.
STEP 02
/ Take the stand top (01B) and place it upside down (leg stumps up) on a clean surface
(note: there is no front or rear to this part). Take the right front leg (04 with a screw hole
in the foot) and slot it over the rear right corner stump. Fix in place using a M6 x 12mm
screw (A) and spring washer (D), but do not tighten. Take the right rear leg (05 with a
screw hole in the foot) and slot it over the front right corner stump. Fix in place using a
M6 x 12mm screw (A) and spring washer (D), but do not tighten.
Take the left front leg (02) and slot it over the rear left leg stump. Fix into place using a
M6x12mm screw (A) and spring washer (D), but do not tighten. Take the left rear leg (03)
and slot it over the front right leg stump. Fix into place using a M6x12mm screw (A) and
spring washer (D), but do not tighten.
STEP 03
/ Take the two bottom shelf supports (06) and t them onto the cylindrical tabs at the
inside of each foot. Rotate each one so that the outmost screw holes are facing inwards
and the inner screw holes are facing the stand top (if not, pull out and t in the opposite
way). Fix in place with four M6x12mm screws (A) and spring washers (D). When all are
assembled, tighten up all four screws and the screws from step 02.
STEP 04
/There are two threaded holes at the inside of the right hand legs. Take the support chain
(15) and x it to the two legs with two M6x12mm screws (A). Tighten fully.
STEP 05
/ Turn the stand onto its legs and check that all of the legs are stable. Take the plastic
bottom shelf (07) and place it on the two bottom shelf supports. Line the four holes in
the bottom shelf up with the threaded holes in the bottom tray supports and x into
position using four M5x12mm screws (B) and four spring washers (E). Tighten fully.
STEP 06
/ Push the at edge of the cylinder hook (14) into the slot of the stand top (above the
right hand side legs and castors) up until the dogleg, and then rotate down until the hook
is against the stand top side. Fix into place using a M6x12mm screw (A), M6 locking nut
(C) and spring washer (D). The stand is now complete.
Loading ...
Loading ...
Loading ...