Loading ...
Loading ...
Loading ...
Changing the Wash Cycle
The wash cycle cannot be changed during washing. If you want to change the wash cycle,
please follow these steps to re-select a wash cycle:
1. Press the Start/Pause button to pause the wash cycle.
2. Press and hold the Power button for 3 seconds to turn off the machine.
3. Press and hold the Power button for 3 seconds to turn on the machine and start a wash
cycle. See “Starting a Wash Cycle” for instructions.
NOTE: As the wash cycle has run for a short time, the detergent may have already been
released and the appliance may have already drained the wash water. It is then required to
refill the water tank if it is in the tank mode, and the detergent dispenser must be refilled. See
“Detergent Use” for instructions.
Forget to Add a Dish?
You can only add a dish if the dishwasher has been running for a short time prior to detergent
being released and water being drained.
NOTE: It is dangerous to open the door when the wash cycle has commenced as the hot
water may scald you. If you do need to open the door completely, press the Start/Pause
button and then slowly open the door.
1. Press the Start/Pause button to stop the wash cycle.
2. After the spray arms stop moving, you can open the door. The LED lamp will then turn on.
3. Add forgotten dishes.
4. Close the door.
5. Press the Start/Pause button. The dishwasher will then resume operation.
At the End of a Wash Cycle
When the cleaning cycle is completed, the machine will drain out the water for 1 minute, and
6 beeps will be heard. It will then begin the drying cycle. When the entire wash cycle is
completed, the machine will automatically enter the standby mode. Note: If the Dry mode is
turned on, the machine will begin the Dry mode after the wash cycle is completed. After the
air drying is finished, the machine will automatically enter the standby mode.
1. Turn off the water supply, if connected. If the water tank will not be used for a long time, it is
recommended to drain the water tank by pressing and holding both the Dry button and
Power button simultaneously for 3 seconds.
2. Unplug the appliance from the power source.
• 17 • • 18 •
NOTE: When the wash cycle is completed, there may be a few droplets on the dishwasher’s
interior or on the tableware. This is normal.
CLEANING & MAINTENANCE
Filter System
NOTES:
• Never run the dishwasher without the filters in place. Improper placement of the filters may
reduce the performance level of the dishwasher and damage dishes and utensils.
• Make sure the filters are properly assembled.
• The entire filter system should be cleaned once a week. Remove food remnants and clean
the filters under running water.
• When cleaning the filters, do not knock them against surfaces. This can contort the filters
and affect the performance of your dishwasher.
The filters prevent larger remnants of food or other objects from getting inside the pump.
For best performance and results, regularly clean the filter system.
The filter system consists of a coarse filter, a flat filter (main filter), and a micro filter (fine filter).
① Coarse filter: This filter traps larger items, such as pieces of bone or glass that could block
the drain.
①
③
②
Loading ...
Loading ...
Loading ...