Loading ...
Loading ...
Loading ...
MODELS B5330SS • B5336SS
Page 7
INSTALL THE HOOD
(Non-Ducted Hoods Only)
NOTE: Non-ducted installations require Non-Duct Kit,
Model RK56 (purchase separately).
1. CAUTION: Do not use plastic or rigid metal duct.
2. Do not remove the protective plastic film covering the
decorative flue and the hood at this time.
3. Lay the back side of the hood flat on a table. Use a piece of
cardboard to avoid damaging the table or the hood.
4. Attach damper / duct connector to top of hood using (4) #8
x 3/8” Pan Head mounting screws.
5. Remove damper flaps from damper / duct connector and
discard flaps.
NON-DUCT KIT MODEL RK56 CONTENTS
8. Measure and install steel ductwork to hood duct connector.
Use duct tape to make all joints secure and air tight.
9. Hold hood up close to wall mounting location and plug
power cord into wall outlet.
10. Align the hood and center it above the hood mounting
bracket. Make sure ductwork on hood lines up and attaches
to ductwork in ceiling. Gently lower the hood until it securely
engages the bracket.
11. Use duct tape to make all joints secure and air tight.
12. With the hood hanging in place, drill through both holes
located in the inside lower back of hood using a
5
⁄16” drill bit.
Insert the included drywall anchors into the drilled holes (one
for each hole). Install (2) washers and (2) #8 x 1-3/16” pan
head mounting screws through the hood back and into the
drywall anchors. Verify that the hood is centered and leveled.
Tighten all screws completely.
13. Reinstall grease filters by aligning rear filter tabs with slots
in the hood. Push back the metal latch tab, push filter into
position and release. Make sure filters are securely engaged
after installation.
14. Slide the upper flue upward until it is aligned with its mounting
bracket. The bracket should be inside the flue. Secure the
upper flue to the upper flue mounting bracket using (2) #8 x
3/8” mounting screws.
15. Remove any protective plastic remaining on hood.
UPPER
FLUE
UPPER FLUE MOUNTING BRACKET
DUCT LENGTH
DECORATIVE
FLUE
6” ROUND
STEEL DUCT
NON-DUCT
PLENUM
2 TIE
WRAPS
FLEXIBLE DUCT
NON-DUCTED
RECIRCULATION
FILTERS
NON-DUCT PLENUM
COLLAR
8 MOUNTING
SCREWS
(ST4 x 8
Round Head)
INSIDE BACK OF HOOD
MOTOR/
BLOWER
ASSEMBLY
HOLE LOCATIONS
SIDE VIEW
Ø 5/16” TYP.
Loading ...
Loading ...
Loading ...